KITCHENAID KESK901SSS, KESS908SPW, KESK901SBL, KERS807SWW, KERS807SSS Dimension Guide

...

30" Freestanding and Slide-In Electric Range

PRODUCT MODEL NUMBERS OVERALL DIMENSIONS

CABINET OPENING DIMENSIONS

SLIDE-IN RANGE COUNTERTOP PREPARATION

KERS807S KESK901S KESS907S KESS908S

Electrical: This range is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire UL listed, 40- or 50amp power supply cord (pigtail). If local codes do not permit ground through the neutral, use a 4-wire power supply cord rated at 250 volts, 40 or 50 amps and investigated for use with ranges.The range can be connected directly to the fused disconnect (or circuit breaker box) through flexible or nonmetallic sheathed, copper or aluminum cable. A UL listed conduit connector must be provided at each end of the power supply cable (at the range and at the junction box). Wire sizes and connections must conform with the rating of the range. A time-delay fuse or circuit breaker is recommended.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

The cooktop sides of the slide-in range fit over the cutout edge of your countertop.

If you have a square finish (flat) countertop and the opening width is 30" (76.2 cm), no countertop preparation is required.

Formed front-edged countertops: Must have molded edge shaved flat 3/8" (1.0 cm) from each front corner of opening.

Tile countertops may need trim cut back 3/8" (1.0 cm) from each front corner and/or rounded edge flattened.

If countertop opening width is greater than 30" (76.2 cm), adjust the 3/8" (1.0 cm) dimension.

Countertop must be level. Place level on countertop, first side to side; then front to back. If countertop is not level, range will not be level. Range must be level for satisfactory baking performance.

WI0118260

09-05-07

Cabinet opening dimensions shown are for 25” (64 cm) countertop depth, 24” (61 cm) base cabinet depth and 36” (91.4 cm) countertop height.

NOTE: 24" (61 cm) min. when bottom of wood or metal cabinet is protected by not less than 1/4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,

0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.

Freestanding Range

F**

A. 5³⁄₄" (14.6 cm) B. 30" (76.2 cm) C. 41³⁄₄" (106 cm) overall

height with leveling legs screwed all the way in

D. 36" (91.4 cm) cooktop trim

height with leveling legs screwed all the way in*

*Range can be raised ap proximately 1" (2.5 cm) by adjusting

the leveling legs.

**When install ed in a 24" (61 cm) base cabinet with 25" (63.5 cm)

countertop; front of oven door protrudes 1" (2.5 cm) beyond 24" (61 cm) base cabinet.

E. 30" (76.2 cm) F. 27 ¹⁄₄" (69.2 cm) max. from

handle to standoff at back of range**

G. Model/serial number plate

(located on the right-hand side oven door trim)

Slide-in Range

E**

A. 30¹¹⁄₁₆" (77.6 cm) B. 35⁵⁄₈" (90.5 cm) height to

underside of cooktop edge with leveling legs screwed all the way in*

C. Model/serial number plate

(located on the right-hand side oven door trim)

*Range can be raised approximat ely 1" (2.5 cm) by adjusting

the leveling legs.

**When installed in a 2 4" (61 cm) base cabinet with 25" (63.5 cm)

countertop; front of oven door protrudes 1³⁄₄" (4.4 cm) beyond 24" (61 cm) base cabinet.

D 30" (76.2 cm) E. 27¼" (69.2 cm) from handle

to standoff at back of range**

F. 23" (58.4 cm) countertop

notch to rear of cooktop

30"

(76.2 cm)

30 ³⁄₄"

(78.1 cm)

³⁄₈"

(1.0 cm)

13" (33 cm)

upper cabinet

depth

30" (76.2 cm) min.

Junction box - 8"

(20.3 cm) to 22" (55.9 cm)

from either cabinet, 7"

(17.8 cm) max. from floor

egnaR gnidnatseerF

For minimum

clearance to the

top of the cooktop,

opening width

30"

(76.2 cm) min.

opening width

Cabinet door

or hinge should not extend into the cutout.

see NOTE*.

13" (33 cm)

upper cabinet

depth

30" (76.2 cm) min.

opening width

(6.2 cm) radius

both corners

Junction box - 8"

(20.3 cm) to 22" (55.9 cm)

from either cabinet, 7"

(17.8 cm) max. from floor

egnaR ni-edilS

1/4"

30"

(76.2 cm) min.

opening width

Cabinet door

or hinge

should not

extend into

the cutout.

For minimum

clearance to the

top of the cooktop,

see NOTE*.

22 3/4" (57.8 cm)

opening depth