KitchenAid KERC601H, KERC607H, KERC608L, KERC700L, KESC300H Dimension Guide

® 30" Freestanding and Slide-In Electric Range

PRODUCT MODEL NUMBERS

KERC601H KESC300H KERC607H KESC308L KERC608L KESC307H KERC700L KESH307H

Electrical: Use 8-gauge solid copper wire. A four-wire or three-wire, singlephase, 120/240-volt, 60-Hz, AC-only, electrical supply is required on a 50ampere maximum circuit, (or, if specified on the model/serial rating plate, a fourwire or three-wire, single-phase 120/208volt, 60 Hz, AC-only electrical supply is available, a 40-ampere maximum circuit), fused on both sides of the line. A timedelay fuse or circuit breaker is recommended. The model/serial rating plate is located on the oven frame behind the drawer.

SLIDE-IN RANGE COUNTERTOP PREPARATION

The cooktop sides of the slide-in range fit over the cutout edge of your countertop.

If you have a square finish (flat) countertop and the opening width is 30", no countertop preparation is required.

Formed front-edged countertops: Must have molded edge shaved flat 1/2" from each front corner of opening.

Tile countertops may need trim cut back

1/2" from each front corner and/or rounded edge flattened.

If countertop opening width is greater than 30", adjust the 1/2" dimension.

Countertop must be level. Place level on countertop, first side to side; then front to back. If countertop is not level, range will not be level. Oven must be level for satisfactory baking conditions.

30" opening

width

1/2"

Formed or tiled 30-7/8" countertop trimmed

1/2" back at front corners of countertop opening.

22-5/8"

Cooktop sides of range fit over edges of countertop opening.

OVERALL DIMENSIONS

	30"
8-1/4"	cooktop
	width	Freestanding
		Range
		44-3/8"
		overall
		height
		36"			Slide-in Range
		cooktop
		height with
		feet loosened			30-7/8"
		1-1/2 turns		1-1/2"	cooktop
					width
				(3.8 cm)
1"spacer
		30"		36"	22-5/8"
			cooktop
27-3/4"		width	height with
				feet
depth with			loosened
handle			1-1/2 turns
				1"
		When installed in a 24"
		base cabinet with 25"
		countertop — front of oven
		door protrudes 1-7/8"
		beyond 24" base cabinet.				30"
					25-3/4"	width
					depth with
					handle
CABINET OPENING DIMENSIONS
25" countertop depth and 24" base cabinet depth,
36" countertop height						For minimum
				Slide-in Range		clearance to the
Freestanding		For minimum				top of the cooktop,
		clearance to the top				see Note.***
Range		of the cooktop, see
		Note.***
					13" max.
		13"max.			upper cabinet depth
	upper cabinet depth				30" min.
		30" min.			cabinet opening width
	cabinet opening width
			18" upper			22-3/4"
18 upper						opening depth
			cabinet to
cabinet to
			countertop
countertop
		30"			1/2"
					radius both
		opening width
					corners	30"
4" min.			4" min.			opening width
			clearance from
clearance from			both sides of
both sides of		junction box –	range to side			junction box – 8"
range to side			wall or other			to 22" from either
		8" to 22" from
wall or other			combustible			cabinet, 7" max.
		either cabinet,
combustible			material.			from floor.
		7" max. from floor.
material.
						7/8" min. required
		7/8" min. required				between cutout and
						cabinet door or hinge.
		between cutout and
		cabinet door or
		hinge.

***Note: 24" min. when bottom of wood or metal cabinet is protected by not less than 1/4" flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper.

30" min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation	Ref. 9755234
Instructions packed with product. Specifications subject to change without notice.	07-17-03