KitchenAid KEMS378HWH2 Installation Instruction
27” and 30” Electric
Quick Reference
Table of Contents:
Pages
1 Product dimensions
cl
1 Cutout dimensions
0
1 Before you start
q
q
Electrical requirements
[q 131 Installation steps
If
you need assistance:
Check your Use and Care Guide for a toll-free number to call or call
the dealer from whom you purchased this appliance. The dealer is
listed in the Yellow Pages of your phone directory under
“Appliances -
Call when you:
LJ Have questions about built-in oven installation or operation.
q
Need to obtain the name and number of an authorized service
company.
When you call, you will need:
q
The built-in oven model number.
Q The built-in oven serial number.
Both numbers are listed on the model/serial rating plate, located on
the microwave oven frame.
Household - Major-Service and Repair.”
Built-in Microwauel
Oven Combination
D
recessed
23” max.
recessed
depth \
41-l 14”
cutout
height
L
-3
l-112”
min.
bottom of
cutout to
top
of
cabmet
cabinet
41”
height
1
v cutout 4
27” oven
25-316
recessed
25-l/2”
width
27” oven
_ 23-114” min.
cutout depth -
* 23” recessed -
oven depth
recessed
oven
1” top of cutout
to bottom of
upper cabinet
door
A
-T
T
19-l 14”
lottom of
:utout to
floor
i
*
*
oven
- front
:
42-7116”
overall
height
30” oven
26-3/W
!
42.7116”
overall
41”
recessed
height
\
h
23” max.
I
recessed
depth \
1” top
of cutout
to bottom
of upper
cabinet door
_L
7
t
41-l/4”
cutout
height
1
-T
l;~~~,mi;~
cutout to
top of
cabinet
k cutout
-
Cabinet filler kits are available from your dealer.
Use a matching color kit if oven is smaller than your
cabinet opening.
27” oven filler height is 7-13/W
Black
White
- 4378950
- 4378951
Almond - 4378952
30” oven filler height is 4-13/W
Black
White
Almond - 4378946
- 4378944
- 4378945
28-w
width
30” oven
b
7
19-l/4”
bottom
,f cutout
to floor
height
Important: Observe all governing codes
and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this oven.
Oven location should be away from strong draft
areas, such as windows, doors and strong
heating vents.
Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed portion
of the oven.
Electrical ground is required. See “Electrical
requirements.”
Electrical supply junction box should be located
3 inches maximum below the support surface
when oven is installed in a wall cabinet. Cutout
for wiring should be in the right rear or left rear
corner. For undercounter installation, it is
recommended that the junction box be located
in the adjacent right or left cabinet. If installing
junction box on rear wall behind oven, junction
box must be recessed and located in the upper
or lower right or left corner of cabinet.
Oven support surface MUST be solid, level and
flush with
bottom of cabinet cutout.
Excessive Microwave Energy Exposure
Do Not attempt to operate the microwave
oven
with the door open.
Do Not tamper with or defeat the safety
interlocks.
Do Not place objects between the microwave
oven front face and door.
Do Not allow soil or cleaner residue to
accumulate on sealing surface of the
microwave oven door.
Do
Not operate the microwave oven if
damaged.
Do Not operate the microwave oven if:
- door is bent.
- hinges and latches are broken or loose.
- door seals, sealing surfaces or glass are
broken.
The microwave oven door must close
properly to provide safe operation.
Have a qualified repair person adjust, repair
and check microwave oven for microwave
leakage after a repair is made.
Do Not use microwave for commercial
purposes. The microwave oven in this unit is
designed for household use only.
Failure to follow these instructions could
result in exposure to excessive microwave
energy.
It is the customer’s responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANSVNFPA 70 - latest edition*,
and all local codes and ordinances.
Copies of the standards listed may be obtained from:
l
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
Tool needed:
Phillips screwdriver
Page 1
Parts supplied:
rews
Cabinet side view
Loading...