KitchenAid RMC305PDQ1, KEHC309JSS, RMC305PDZ1, RMC305PDZ2, RMC305PDQ4 Installation Guide
...
27" and 30" Electric
Built-in Microwave/
Quick Reference
Table of Contents:
Pages
_1-_Product dimensions
[_ Cutout dimensions
[] Before you start
[] Electrical requirements
[_ _ Installation steps
If you need assistance:
Check your Useand Care Guide for a toll-free number to call or call
the dealer from whom you purchased this appliance. The dealer is
listed in the Yellow Pages of your phone directory under
"Appliances -- Household -- Major -- Service and Repair."
Call when you:
Have questions about built-in oven installation or operation.
[_ Need to obtain the name and number of an authorized service
company.
When you call, you will need:
The built-in oven model number.
[_ The built-in oven serial number.
Both numbers are listed on the model/serial rating plate, located on
the microwave oven frame.
Oven Combination
recessed
23" max.
recessed
depth
41-1/4"
cutout
height
1-1/2"
min.
bottom of
cutout to
top of
cab,net
door
cabinet ----
27" oven
41"
height
"_ 27"min.
cabinetwidth
25-1/2"
,._----- cutout --
27" oven
23-1/4"min.
q[---- cutout depth
23"recessed
oven depth
recessed
25-3/8
recessed
width
oven
,26-314"
1"top of cutout
tobottomof
upper cabinet
door
f
19-1/4"
bottom of
cutout to
floor
_3_
oven
"_front
42-7/16"
overall
height
J
30" oven
28-3J8"
42-7/16"
41"
recessed
height
J
23" max.
recessed
depth
"9_'-- 30" mm.
cabinet
J
29-314"
1"top
of cutout
to bottom
of upper
cabinet door
T
41-I/4"
cutout
height
l,
1-1/2" rnin.
bottom of
cutout to
top of
cabinet
door
Cabinet filler kits are available from your dealer.
Use a matching color kit if oven is smaller than your
cabinet opening.
27" oven filler height is7-13/16"
Black -- 4378950
White -- 4378951
Almond- 4378952
30" ovenfiller height is 4-13116"
Black -- 4378944
White -- 4378945
Almond- 4378946
2S-1/2"
cutout ---_
width
30" oven
i
19-1/4"
bottom
of cutout
tofloor
_I_
overall
height
Important: Observe all governing codes
and ordinances.
Proper installation isyour responsibility.
Have a qualified technician installthis oven.
Oven location should be away from strong draft
areas, such aswindows, doors andstrong
heating vents.
Cabinet opening dimensionsthat are shown
must be used. Given dimensions provide
minimum clearance.
Recessedinstallation area must provide
complete enclosure aroundthe recessedportion
ofthe oven.
Electrical ground isrequired. See "Electrical
requirements."
Electrical supply junction box should be located
3 inches maximum below the support surface
when oven is installed in a wall cabinet. Cutout
for wiring should be in the rightrear or left rear
corner. Forundercounter installation, it is
recommended that the junction box be located
in the adjacentright or left cabinet. If installing
junction box on rear wall behind oven, junction
box must be recessedand located in the upper
or lower right or left corner of cabinet.
Oven support surface MUST besolid, level and
flush with bottom of cabinet cutout.
Excessive Microwave Energy Exposure
Do Not attempt to operate the microwave
oven with the dooropen.
Do Not tamper with or defeat the safety
interlocks.
Do Not place objects betweenthe microwave
oven front face and door.
Do Not allow soil or cleaner residueto
accumulate on sealing surfaceof the
microwave oven door.
Do Not operate the microwaveoven if
damaged.
Do Not operate the microwaveoven if:
-- door is bent.
-- hinges and latches are broken or loose.
-- door seals, sealing surfaces or glass are
broken.
The microwave oven door must close
properly to provide safe operation.
Havea qualified repairperson adjust, repair
and check microwave oven for microwave
leakage after a repair is made.
Do Not use microwave for commercial
purposes. The microwaveoven in this unit is
designed for household use only.
Failure tofollow these instructions could
result in exposure to excessive microwave
energy.
It is the customer's responsibility:
To contact a qualified electrical installer.
To assure that theelectrical installation is
adequate and in conformance with National
Electrical Code, ANSI/NFPA 70-- latest edition*,
and all local codes and ordinances.
Copies of the standards listed may be obtained from:
* National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
Tool needed:
Phillips screwdriver
Page 1
Parts supplied:
Cabinet side view
Loading...