KitchenAid KEBC277KSS05, KEBC277KBL05, KEBC171KWH06, KEBC247KWH05, KEBC171KBL06 Installation Instructions Manual

Quick Reference

Table of Contents:

Pages

E_ Product dimensions
[_ Cutout dimensions
E_ Before you start
[_ Electrical requirements
[_] Installation steps

If you need assistance:

Checkyour Use and Care Guide for atoll-free number to call or call

the dealer from whom you purchased this appliance. The dealer is

risted in the Yerlow Pages of your phone directory under
"Appliances -- HousehoMd-- Major -- Service and Repair,"

Call when you:

Have questions about built-in oven installation or operation.
Need to obtain the name and number of an authorized service
company.

When you call, you will need:
D The builbin oven model number.

The built-in oven serial number.

Both numbers are listed on the model/serial rating plate, located on

the oven door or on the oven frame.

27=1/2"
recessed

height

Single oven

25=3/8" max.

recessed

width

\

29"max_

overall
height

27=3/4"
min.

cutout

height

27"min, ___

cabinet width

-

1=1/2" min.

top of cutout
to underside

of ceuntertep

_

25-1/2"

cutout width

5=I/4" bottom of
cutout to f_oer

Single oven

undercounter

{without cooktop

installed above)

T

27=3/4"

min.

cutout

height

1=I/2"

min,

bottom of

cutout to

top of

cabinet

door

27" min,

cabinet width

25=1/2"

_--- cutout ---:_

width

1" top of cutout
to bottom of

upper cabinet

door

t

32"

bottom of
cutout to

floor

Single oven

Double oven

25=3/e"max.

recessed width

49-1/2"

recessed

height

26=314"

j-

61" max,

overs[[
height

r_

J

49-3/4"

min,

cutout

height

1=1/2" min,

bottom of

cutout to top of

cabinet door

27" ram.

_--- cabinet --_

I [

25=1/2"

_--- cutout --_

width

Double oven

1" top 01 cutout
to bottom of

upper cabinet

door

14=3/4"

bottom

of cutout

to fleer

cabinet -_

2e=li4"mim

cutout depth
23"recessed

oven depth

recessed

oven

oven

J'_ front

Cabinet side view

Your safety and the safety of others are

very imp0rtaet.

We have provided many important safety

messagesin this manualand on your appliance,

AtwayereadandobeyaHsafety messages=

This is the safety alertsymbol.
Thissymboi alertsyou to potentiai hazards

that cankiii or hurtyou and others.

Ati safety messageswiii foiiow the safetyalert
symbol andeithertheword "DANGER"or

"WARNING".Thesewords mean:

You can be killed or seri0usly injured if you don't
follow instructions.

Ati safety messageswiii teli you what the potential

hazardis, tell you howto reducethe chance of
injury, andteti you what can happenif the
instructions are not followed.

important: Observe ali governing codes
and ordinances.

Proper installation is your responsibility.
Have a qualified technician install this oven.

Oven location should beaway from strong draft
areas, such as windows, doors and strong
heating vents.

Cabinet opening dimensions that are shown
must be used. Given dimensions provide

minimum clearance.
Recessed installation area must provide

complete enclosure around the recessed portion
of the oven.

Electrical ground is required. See "Electrical
requirements."

Electrical supply junctionbox should be located
3 inches maximum below the support surface
when oven is installed in a wall cabinet. Drill a
1°inch minimum diameter hole in the right rear
or left rear corner ofthe support surface to pass
the appliance cable through to the junction box.
For undercounter installation, it is recommended
that the junction box be located in the adjacent
right or left cabinet. If installing the junction box
on rear wall behind oven, junction box must be
recessed and located in the upper or lower right
or left corner of cabinet.

Oven support surface MUST be solid, [eve[ and
flush with bottom of cabinet cutout.

it is the customer's responsibility:
To contact aqualified electrical installer.

To assure that the electrical installation is
adequate and in conformance with National

Electrical Code, AN81/NFPA 70 E latest edition*,
and nit local codes and ordinances.

Copies of the standards listed may be obtained from:
* National Fire Protection Association

Battervmamh Park
Quincy, Massachusetts 02269

Tool needed:

S

screwdriver

Partssupplied:

4 screws (double oven)

Page 1