KitchenAid KBHC109JWH0, KBMC140HWH0, KBMC147HWH05, YKBMC140HS0, YKBMC140HS03 Installation Guide

20=1/2"

(52,1 cm}

overall

height

23" (58,3 cm)

max, recessed

depth

27" (68.6 Cm)m/w Oven 25-3/8" (64.5 cm) 26-3/4" (67.9 cm)
30" (76.2 cm)mlw oven 28-3/8'!(72.1 cm) 29=314'!(75.6 cm)

Yoursafety and the safety of othersare

veryimportant.

Wehaveprovided many important safety
messagesinthis manualand on your appliance=
Always readand obeynil safety'messages.

This isthe safety'alert symbol.
This symbolalerts youto potentiaihazards

that can kiii or hurt you andothers.

Atisafety messageswiii foliow the safety alert
symbol and eitherthe word "DANGER"or

"WARNING".Thesewords mean:

Youcan be killed or seri0usty injuredif y0u
don't feH0w instructions.

Aii safety messageswiii teti you what the potential
hazardis, toil you how to reducethe chance of
mjury, and teti you what can happenif the

instructions arenot followed.

7-

19=7/16"

(4&4 cm}

cutout

height

1=1/2"

{3&1 cm}

min.

bottom of

cutout to

top of

cabinet

door

cabinet width

_-- cutout --

B

width

1" (25,4 cm)

top of cutout
to bottom

of upper

cabinet door

40"

{101,2 cm)

bottom of

cutout to

floor

23ol/4" {5&1 cm} ___

min, cutout depth

23" (5&4 cm)

recessed oven

depth

cabinet _

recessed

oven

"//front

oven

Cabinet side view

Electrical supply junction box shouM be Uocated
3 inches (7.6 cm) maximum beUowthe support

surface when oven is installed in a wall cabinet.
Cutout for wiring should be inthe right rear or

left rear corner. For undercounter installation, it
is recommended that the junction box be
located in the adjacent right or left cabinet. If
installing junction box on rear wall behind

oven, junction box must be recessed and
located in the upper or lower right or left corner

of cabinet.

important: Observe all governing codes
and ordinances.

Proper installation is your responsibility.
Have a qualified technician install this oven.

Oven location should be away from strong
draft areas, such as windows, doors and strong
heating vents.

Cabinet opening dimensions that are shown
must be used. Given dimensions provide

minimum clearance.
Recessed installation area must provide

complete enclosure around the recessed
portion of the oven.

ElectricaJ ground is required. See "Electrical
requirements."

EiectricaJ supply junction box should be located
3 inches (7.6 cm) maximum below the support

surface when oven is installed in a wall cabinet.
Cutout for wiring should be inthe right rear or

left rear corner. For undercounter installation, it
is recommended that the junction box be

located in the adjacent right or left cabinet. If
installing junction box on rear wall behind
oven, junction box must be recessed and
located in the upper or lower right or left corner

of cabinet.
Oven support surface MUST be solid, level and

flush with bottom of cabinet cutout.

' ° A ' B ¸¸ '

27" (68.6 cm) m/w oven 27" (68.8 Cm)25-1/2" (64.8 Cm)
30'!(76.2 Cm)m/w oven 30'! (76.2 cm) 28q/2" (72.4 cm)

Tool needed:

Phillipsscrewdriver

Partssupplied:

_2 screws

Excessive Microwave Energy Exposure

Do not attempt to operate the
microwave oven with the door open.

Do not tamper with or defeat the safety

interlocks.

Do not place objects between the
microwave oven front face and door.

Do not allow soimor cleaner residue to
accumulate on sealing surface of the

microwave oven door.
Do not operate the microwave oven if

damaged.
Do not operate the microwave oven if:

-- door is bent.

-- hinges and latches are broken or

loose.

-- door sea_s, sealing surfaces or
glass are broken.

The microwave oven door must close
properly to provide safe operation.

Have a qualified repair person adjust,
repair and check microwave oven for
microwave leakage after a repair is

made.
Do not use microwave for commercial

purposes. The microwave oven in this
unit is designed for household use
only.
Failure to foltow these instructions

could result in exposure to excessive
microwave energy.

Page 1

Copies of the standards listed may be obtained from:

Nationa_ Fire Protection Association
One Batterymarch Park

Quincy, Massachusetts 02269

_ CSA International

850I East Pleasant Valley road
C_eveJand, Ohio 44131-5575

It is the customer's responsibility:

To contact a qualified electrical installer.
To assure that the electrical installation is

adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 _ latest
edition*, or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No. 0-M91 -

latest edition** and nit local codes and
ordinances.