Washer
IMPORTANT:
Read and save
these instructions.
IMPORTANT
Installer: Leave Installation Instructions
Homeowner: Keep Installation Instructions
Save Installation Instructions for local
with the homeowner.
for future reference.
electrical inspector’s use.
Before you start... 11
Check location where washer wrll
be installed. Proper installation is
your responsibilily. Make sure
you have everylh’ln(
for correct inslallalion.
Grounded eleclrlcal outlet is ,’
required. See Electrical
requiremenls.
Slandplpe dram syslem: Needs
a two-inch minimum diameter
slandpipe with minimumcarry-awaY
--..I ----I
capacity of
17 gallons per
minute. Top 01
standpipe must
be al least 34
72 inches from
bottom of
washer.
Floor dram
No. 255320. d j--/f
Unlape and open
packages and ho!
I
Observe all governlng
ordinances.
washer lid. Remove
ses from washer.
I.“. “la” .,“a” ..“a., m-1”“.-. 1.111. I
within 4 feet of Ihe beck 01 the washt
and provide waler pressure 5-100 PSI.
Leundry tub draln cyslem: Needs a
20.oallon laundrv tub. Too of lub must
II II
be aI least 34 inches high’and no
1
higher than 72 inches lrom botlom 01
washer.
I
If a longer drain hose is keeded,
drain hose (Part No. 366423) and
hose extension kit (Part No.
265442) are available lrom
1 / dislributors.
KitchenAid-aulhorized parts
/
/
waler lo washer.
SEERECESSED
INSTRUCTIONS ON
BACK COVER.
Tools needed for
installation:
Parts supplied for
installation:
Remove parts horn packages. Check that
all parts were included.
eve1 floor: Maximum slope
nder 60,ti@ washer 1 inch.
loor must be sturdy enough to
Sectrical
‘equirements
Eleclrlcal Shock Hazard
- Eleclrlcal ground Is required on
lhls appliance.
l
If cold waler plpe Is Interrupted by
plasllc, non-metalllc gaskets or
olher insulallng melerlals, Do Nol
uss for groundlng.
. Do Not ground lo a gas pipe.
a Do Not modify Ihe power supply
cord plug. II It does not fit the
oullel, have a proper oullet
Installed by a qualllied eleclrlclan.
* Do Not have a fuse In lhe neutral
or groundlng clrcult. A fuse In lhe
neutral or aroundlna clrcull could
result In arieleclrlc~l shock.
- Do Nol use an exlenslon cord wllh
this appliance.
. Check wllh a quallfled eleclrlclsn
If you are In doubt as to whether
the appliance Is properly
grounded.
Fallure lo lollow lhese lnslrucllons
could result in serious Injury or
death.
codes permll and a separate
,oundlna wire Is used. II Is
commended lhat a quelllied
eclrlclan delermlne that the
oundlng path Is adequale.
!O-Voll. 60-Hz. AC-only, 15- or 20.
npere fused electrical supply Is
quired. (Time-delay luse or circuit
eaker is recommended.) II is
commended lhal a separate circuil
rving only this applianoe be provided,
Product Damage
Do Not store or operale
washer below 32°F (some
waler may remaln In
washer).
See Use & Care Gulde for
“Wlnlerlzlng” Informallon.
Fellure lo follow above may
resull In pro&cl damage.
Recommended
grounding method
For your personal safely, this appliance
must be grounded. This appliance is
equipped with a power supply cord
having a 3-prong grounding plug.
minimize possible shock hazard. the cord
must be plugged inlo a mating J-prong
groundmg-type wall receptacle, grounded
in accordance with National Electrical
Code, ANSllNFPA 70.lalesl edition and
all local codes and ordinances. See
Figure 1. If a maling wall receptacle Is
not available, it is the personal
responsibility and obligalion of the
customer lo have a properly grounded 3prong wall receptacle inslalled by a
qualified electrician.
Flgure 1
To
Panel A