KitchenAid 3182137 User Manual
KCtchenACd”
Electric Built-in 30”
Thermal Single and
Double Ovens
30” Thermal
Convection Single
and Double Ovens
IMPORTANT:
Part No. 3182137 Rev. E
Read and save
these instructions.
IMPORTANT:
Installer:
homeowner.
Homeowner:
future reference.
Save
inspector’s use.
Leave Installation Instructions with the
Keep Installation Instructions for
Installation Instructions for local electrical
30” Single oven
I -w--q-
t-i-
I
00
Not seal
oven to
cabinets.
Ill
32’ min. recommended
so oven door, when
open, is 36’ from floor.
r
I
’
I II
2-112’ min.
See Note.*
I II
I
I I
*Note: There must be 1’
min. between bottom of
cabinet door
oven console.
Oven control
_____,_
===+ 3!.,6”-
and top of
-.-.m.-
See Note.*
1
Before you start...
Read the electrical and carpentry instructions.
Proper installation is your responsibility. A
qualified technician should install this oven. Make
sure you have everything necessary for correct
installation. It is the responsibility of the installer to
comply with the installation clearances specified
on the seriaVrating plate. The serial/rating plate
can be found behind the oven door (double oven
models
Check location
installed. The location should be away from strong
draft areas, such as windows, doors, and strong
heating vents. The built-in oven should be located
for convenient use in the kitchen.
Cabinet opening dimensions
must be used. Dimensions given are for a built-in
oven sitting on a contact surface 2-314” below the
open oven door height. The contact surface must
be solid and level and flush with the bottom of the
cabinet opening.
The recessed installation area
complete enclosure around the recessed portion
of the oven.
ALL OPENINGS IN THE WALL OR FLOOR
WHERE THE BUILT-IN OVEN IS TO BE
INSTALLED MUST BE SEALED.
Electrical ground
requirements.”
Do Not install single oven in a base cabinet
with a countertop above it.
- upper oven) on the frame of the oven.
where the built-in oven will be
that are shown
must provide
is required. See “Electrical
30” Double oven
w; Note
2-W” min.
The oven support surface must be flush
with the bottom of the cabinet opening.
I
Important: Observe all governing codes
ordinances.
Electrical Shock Hazard
lt is the customer’s responsibility:
l
To contact a qualified electrical installer.
l
To assure that the electrical installation is
adequate and in conformance with
National Electrical Code, ANSUNFPA
70 - latest edition**, and all local codes
and ordinances.
Failure to do so could result in fire,
electrical shock or other personal injury.
*Note: There must be 1’
min. between bottom of
cabinet door and top of
.
oven console.
Oven control
console
Securely fasten oven to cabinet using the
screws 4 screws provided (8 screws for
double oven).
Failure to do so could cause the oven to
Personal Injury Hazard
move or tip during use and result in
personal injury.
00 Not seal
oven to
cabinets.
I
66&6’ 1
opening I
height I
I
recommended so
upper oven door,
when open is 36”
Tools needed for
installation:
;’
I
667;16”-
recessed
oven height
68-Y8’ -
See Note:
II ,
overall
height
Darts supplied for
nstallation:
rews (single
crews 1 (doub e)
Panel A
Loading...