KIRLOSKAR CF 220, CF 550, CF 110, CF 330, CF 440 Instruction On Installation, Operation And Maintenance

KIRLOSKAR BROTHERS LIMITED
KIRLOSKARVADI 416 308

INSTRUCTIONS

ON

INSTALLATION,

OPERATION

AND

MAINTENANCE

FOR
KIRLOSKAR
PUMP TYPE

“ CF “

KIRLOSKAR BROTHERS LIMITED
KIRLOSKARVADI 416 308

WARRANTY

We warrant that the pump supplied from us is free from defective

material and faulty

workmanship. This warranty holds good for a

period of 12 months from the date of

commissioning the equipment or 18 months from

the date of despatch from our factory,

whichever is earlier. Our liability in

respect of any complaint is limited to

replacing part/parts free of charge ex-works

or repairs of the defective part/parts only

to the extent that such replacement / repairs

are attributable or arise solely from faulty

workmanship or defective material.

This warranty holds good only for the products manufactured by us.

- KIRLOSKAR BROTHERS LIMITED

KIRLOSKAR BROTHERS LIMITED
KIRLOSKARVADI 416 308

1. GENERAL.

CONTENTS

2. INSTALLATION.

3. OPERATION.

4. TECHNICAL DATA.

5. MAINTENANCE.

6. OVERHAULING.

7. SPARE PARTS LIST AND
CROSS SECTIONAL DRAWING.

KIRLOSKAR BROTHERS LIMITED
KIRLOSKARVADI 416 308

1. GENERAL:

1.1 The booklet covers instructions for following types of CF series horizontal pumps.

CF 110 (CF 111 to CF 118)
CF 220 (CF 221 to CF 228)
CF 330 (CF 331 to CF 338)
CF 440 (CF 441 to CF 448)
CF 550 (CF 551 to CF 558)

1.2 Cold model pumps (without stuffing box cooling arrangement) are supplied for

clear liquid having temperature up to 90 degree C. Above 90 degree C, stuffing
box cooling arrangement is required and are suitable up to 120 degree C.

1.3 Pumps, when properly installed and given due care in operation and maintenance,

should operate satisfactorily for a long period of time, when the pump is received
sometime before the actual use of the pump, it should be indicated and located in
a dry place. The coupling should be rotated once in a month to prevent pitting of
bearing surfaces.

1.4 Each pump is subjected to a functional test prior to shipment. The manufacturer

only warrants the correct functioning of the pump-set on condition that it is
installed and started up in full compliance with the instructions contained in this
manual. In the event of a warranty claim the pump must not be opened. Any
manipulations performed on the pump by a third party shall release the
manufacturer from his warranty obligations.

The nameplate of the pump/pump-set states the pump number, type designation
and the given duty data. The pump shall only be operated at the duty data stated
in the purchase order.

Queries, orders for spare parts etc can only be handled if the pump number is
indicated.

These operating instructions do not overrule local safety regulations.