Kirisun Communication PT420803 Users Manual

Page 1 of 22

INSTRUCTION MANUAL

PT4208

Your KIRISUN radio generates RF electromagnetic energy during

transmit mode. This radio is designed for and classified as “Occupational Use Only”, meaning it must be

used only during the course of employment by individuals aware of the hazards, and the ways to minimize

such hazards. This radio is NOT intended for use by the “General Population” in an uncontrolled

environment.

This radio has been tested and complies with the FCC RF exposure limits for “Occupational Use Only”. In

addition, your KIRISUN radio complies with the following Standards and Guidelines with regard to RF

energy and electromagnetic energy levels and evaluation of such levels for exposure to humans:

FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating Compliance with FCC Guidelines for

Human Exposure to Radio Frequency Electromagnetic Fields.

American National Standards Institute (C95.1-1992), IEEE Standard for Safety Levels with Respect to

Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz. American National

Standards Institute (C95.3-1992), IEEE Recommended Practice for the Measurement of Potentially

Hazardous Electromagnetic Fields– RF and Microwave.

The following accessories are authorized for use with this product. Use of accessories other than those (listed

in the instruction) specified may result in RF exposure levels exceeding the FCC requirements for wireless

RF exposure.

To ensure that your expose to RF electromagnetic energy is within the

FCC allowable limits for occupational use, always adhere to the following guidelines

DO NOT operate the radio without a proper antenna attached, as this may damaged the radio and may also

cause you to exceed FCC RF exposure limits. A proper antenna is the antenna supplied with this radio by the

manufacturer or antenna specifically authorized by the manufacturer for use with this radio.

DO NOT transmits for more than 50% of total radio use time (“50%duty cycle”). Transmitting more than

50% of the time can cause FCC RF exposure compliance requirements to be exceeded. The radio is

Page 2 of 22

transmitting when the “TX indicator” lights red. You can cause the radio to transmit by pressing the “PTT”

switch.

ALWAYS keep the antenna at least 2.5 cm (1 inch) away from the body when transmitting and only use the
KIRISUN belt-clip which is listed in instructions when attaching the radio to your belt, etc., to ensure FCC

RF exposure compliance requirements are not exceeded. To provide the recipients of your transmission the

best sound quality, hold the antenna at least 5 cm (2 inches) from your mouth, and slightly off to one side.

The information listed above provides the user with the information needed to make him or her aware of RF

exposure, and what to do to as-sure that this radio operates with the FCC RF exposure limits of this radio.

Electromagnetic Interference/Compatibility During transmissions, your KIRISUN radio generates RF

energy that can possibly cause interference with other devices or systems. To avoid such interference, turn

off the radio in areas where signs are posted to do so. DO NOT operate the transmitter in areas that are

sensitive to electromagnetic radiation such as hospitals, aircraft, and blasting sites.

Occupational/Controlled Use The radio transmitter is used in situations in which persons are exposed as

consequence of their employment provided those persons are fully aware of the potential for exposure and

can exercise control over their exposure.

IMPORTANT
READ ALL INSTRUCTIONS carefully and completely before using the transceiver
SAVE THIS INSTRUCTION MANUAL- This instruction manual contains important operating

instructions for the Two-Way Radio

EXPLICIT DEFINITIONS

OPERATING NOTES

When transmitting with a portable radio, hold the radio in a vertical position with its microphone 5 to 10 cm

(2 to 4 inches) away from your mouth. Keep the antenna at least 2.5 cm (1 inch) from your head and body.

If you wear a portable two-way radio on your body, ensure that the antenna is at least 2.5 centimeters (1 inch)

from your body when transmitting.

PRECAUTIONS WARNING!
NEVER hold the transceiver so that the antenna is very close to, or touching exposed parts of the body,

especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 5 to 10

cm (2 to 4 inches) away from the lips and the transceiver is vertical.

WARNING!
NEVER operate the transceiver with a headset or other audio accessories at high volume levels.
CAUTION!
NEVER short the terminals of the battery pack. NEVER connect the transceiver to a power source other

than the Battery listed below Such a connection will ruin the transceiver.

DO NOT push the PTT when not actually desiring to transmit.
AVOID using or placing the transceiver in direct sunlight or in areas with temperatures below –30°C (–22°F)

or above +60°C (+140°F).

DO NOT modify the transceiver for any reason.
MAKE SURE the flexible antenna and battery pack are securely attached to the transceiver, and that the

antenna and battery pack are dry before attachment. Exposing the inside of the transceiver to water will

result in serious damage to the transceiver.

Page 3 of 22

BE CAREFUL! The series transceivers employ waterproof construction, which corresponds to IPX7 of the

international standard IEC 60529 (2001), 1 m depth for 30 minutes. However, once the transceiver has been

dropped, waterproofing cannot be guaranteed due to the fact that the transceiver may be cracked, or the

waterproof seal damaged, etc. The use of non-KIRISUN battery。
FCC CAUTION: Changes or modifications to this device, not expressly approved by KIRISUN, could

void your authority to operate this transceiver under FCC regulations.

Page 4 of 22

FCC INFORMATION FOR Q5EPT420803

This device compliance with Part 90 of the FCC rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device must

except any interference received, including interference that may cause undesired operation.

FCC ID: Q5EPT420803

Page 5 of 22

Preface

We are very grateful for your purchasing brand two-way

radios produced by Kirisun Electronics (Shenzhen) Co., Ltd.We believe

two-way radio, which always incorporates the latest technology, can bring great convenience

to your life and work; we also believe that the quality and function of two-way

radio can meet your demands for reliable communication.

PRECAUTIONS

Please observe the following precautions to prevent fire,personal injury,and radio damage.

Do not operate your radio while taking on fuel,or being charged.

Do not expose the radio for a long period to direct sunlight,nor place the radio close to heating

appliances.

Do not place the radio in excessively dusty areas,humid areas,or on unstable suffaces.

Do not modify this radio for any reason.

Refer service to qualified licensed or certificated technicians only.

Notices to the User

Government laws prohibit radio communication without permission in government

districts.

Page 6 of 22

Illegal operation is subject to punishment by fine and/or imprisonment.

Refer service to the well-trained professional technicians only.

Safety

It is important that the user is aware of and understands hazards common to the operation of any

radios.

Warning!

Turn off your radio before entering any area with a potentially explosive atmosphere (where the air

contains gas,dust and smog,etc.),such as while taking on fuel,or while parking at a gasonline service station.

Precaution in Use

Please comply with the following attentions to avoid fire,bodily injure and damage to the radio.

The radio is recommended to transmit for 1 minute and receive for 4 minutes.Long time transmitting

or continuous working in high power mode will make the rear side of the radio generate heat.

Please don’t disassemble or assemble the radio under any circumstances.

Please don’t expose the radio to direct sunlight for a long time;don’t place the radio near any heating

devices,either.

Pease don’t put the radio in extremely dusty,most or dabbling places;don’t place it on any unstable

surfaces,either.

If the radio emits smoke or strange odors,turn it off and remove the battery from the radio and

promptly contact your local authorized Kirsun dealer.

Page 7 of 22

1. Package-opened Inspection and Installing

2. Preparation

2.1. Charge the battery

2.2. Install/remove the battery

2.3. Install the antenna

2.4. Install external speaker/MIC

2.5. Install the belt clip

3.Radio Overview

4.Basic Operation

5.Programmable Key Function

6.Auxiliary functions

CONTENTS

6.1.TOT timer

6.2.Battery saving

6.3.Low battery alarm

6.4.Number announcement

6.5.Continuous Tone Controlled Squelch System (CTCSS) /Digital Controlled Squelch System

(DCS)

6.6.Dual Tone Multi-Frequency (DTMF) coding

6.7.Talkaround

6.8.Scan

6.9.Transmission Begin and Transmission End Signals (PTT Id)

6.10.Lone worker

6.11.Emergency Alarm

8.Trouble Shooting Guide

9.Major Specifications