Kira Home KLAL1517 Installation & Assembly

ITEM #: RVY-WB5484-3

For any replacement parts or installation issues, please Contact Us!
Email: [e-mail]
Facebook/Instagram: @KiraHomeDecor
Phone: [phone]

IMPORTANT SAFETY INSTRUCTIONS

• To avoid injury or damage, mount only on a surface that is sturdy.

• To avoid electric shock, make sure the electricity is turned off at the main
circuit breaker panel. If you are replacing an existing fixture, turn off the
following in order: fixture, wall switch, and main fuse or breaker box.

Note: Some types of fuses must be unscrewed to shut the power off.

• If you are unclear as to how to proceed, please consult a licensed
electrician.

UNPACK THE FIXTURE: Check the contents of the box. Box should contain all items on the parts diagram.

INSTALLATION INSTRUCTIONS

1. Secure Mounting Plate (A) to existing junction box using Mounting Screws (B) provided. Use a leveling tool

to ensure that Mounting Plate (A) is level.

Note: Mounting Plate (A) should be attached to the back of the fixture. Remove it.

2. Using the pre-drilled holes on Mounting Plate (A), mark location to install Plastic Anchors (H). Remove

Mounting Plate (A) and drill pilot holes on the marked spots and insert Plastic Anchors (H).

Note: Plastic Anchors (H) should sit flush with the wall.

3. Re-secure Mounting Plate (A) to the junction box (not included) using Mounting Screws (B) and Anchor

Screws (G) provided. Ensure Mounting Plate (A) is positioned with the brackets on the top and bottom.

4. Using the wire graph below, connect the appropriate wires from the fixture to the corresponding wires in the
electrical junction box (not included) and secure Wire Connectors (C).

A. Connect the ground wire (bare copper or green) from

your fixture to the:

1) ground wire in the junction box, or

2) ground screw in the junction box

B. Connect the BLACK house wire to fixture hot wire

that corresponds to diagram (black, round &
smooth, white/grey with tracer, brown/gold without
tracer).

C. Connect the WHITE house wire to fixture neutral wire

that corresponds to diagram (white, ribbed/ridged,
white/grey without tracer, brown/gold with tracer).

5. Place all wires and Wire Connectors (C) back into the junction box.

6. Place Backplate Assembly (D) against the wall, ensuring holes on each side of Backplate Assembly (D)

align with the holes on Mounting Plate (A). Secure Backplate Assembly (D) to Mounting Plate (A) with
Backplate Screws (E).

7. Secure Shades (F) to Sockets (J) with Socket Rings (I).
Note: Socket Rings (I) should already be attached to Sockets (J). Remove Socket Rings (I) prior to
installing Shades (F).

8. Install light bulbs (not included) into Sockets (J).

Enjoy your new fixture!

ITEM #: RVY-WB5484-3 - PARTS DIAGRAM

HELPFUL TOOLS: Safety Goggles, Screwdriver, Ladder, Measuring Tape