Kipor SINEMASTER IG1000, SINEMASTER IG2000, SINEMASTER IG2000P, SINEMASTER IG2600, SINEMASTER IG2600P Operation Manual

Third Stage Development Section of

Wangzhuang Industry Area, Wuxi High &

New Technology Industry Development Zone

Wuxi, Jiangsu Province, PRC

TEL: [phone]

FAX: [phone]

E-MAIL: [e-mail]

Version 1, Printing date June 1, 2011

MADE IN CHINA

Beside Jingyi Road

SINEMASTER

DIGITAL GENERATOR

IG1000, IG1000P

IG2000, IG2000P

IG2600, IG2600P

OPERATION MANUAL

1

PREFACE

Thank you for purchasing a Kipor generator.

This manual covers operation and maintenance of the IG1000, IG2000, and IG2600 generators

including parallel versions.

All information in this publication is based on the latest product information available at the time of
approval for printing.

We reserve the right to make changes at any time without notice and without incurring any

obligation.

No part of this publication may be reproduced without written permission.

This manual should be considered a permanent part of the generator and should remain with it if it
is resold.

Pay special attention to statements preceded by the following words:

Failure to properly follow these precautions can result in property damage,

serious injury or DEATH!
Read all labels and the owner's manual before operating this generator.

Generators produce carbon monoxide, a poisonous, colorless, odorless
gas that can cause death or serious injury.

Indoor use of a generator can kill quickly. Generators should be used
outdoors only

Generators should be used outdoors only and away from garages and
open windows and protected from rain and snow.

Check for spilled fuel or leaks. Clean and/or repair before use.
Always stop engine before refueling. Wait 5 minutes before restarting.

Keep any source of ignition away from fuel tank, at all times.
The portable generator is not meant to be used as a permanent back-up

power system for the home. A permanently installed stationary generator
is designed to be safely used for this specific purpose.

Indicates a strong possibility of severe personal injury or death if
instructions are not followed.

Indicates a possibility of personal injury or equipment damage if
instructions are not followed

2

Gives helpful information.

If a problem should arise, or if you have any questions about the generator, consult an authorized

dealer.

Our generators are designed to give safe and dependable service if operated according to
instructions. Read and understand the Owner's Manual before operating the generator. Failure to

do so could result in personal injury or equipment damage.

3

CONTENTS

PREFACE .................................................................................................................... 1

1. SAFETY INSTRUCTIONS ....................................................................................... 4

2. SAFETY LABEL LOCATIONS ................................................................................. 6

3. COMPONENT IDENTIFICATION ............................................................................ 7

4. PRE-OPERATION CHECK...................................................................................... 10

5. STARTING THE ENGINE........................................................................................ 14

6. GENERATOR USE .................................................................................................. 16

7. STOPPING THE ENGINE ....................................................................................... 26

8. PARALLEL GENERATOR OPERATION ................................................................ 27

9. MAINTENANCE ....................................................................................................... 30

10. TRANSPORTING/STORAGE................................................................................ 38

11. TROUBLESHOOTING ........................................................................................... 40

12. SPECIFICATIONS ................................................................................................. 42

13. WIRING DIAGRAMS ............................................................................................. 43

14. WARRANTY........................................................................................................... 45

15. APPENDIX A- IG2600H HANDLE ...................................................................... 51

16. APPENDIX B- MOBILE LIGHT KIT..................................................................... 52

4

1. SAFETY INSTRUCTIONS

■ This generator is designed to give safe and dependable service if

operated according to instructions.

Read and understand the Owner's Manual before operating the

generator. Failure to do so could result in personal injury or

equipment damage.

■ Exhaust gas contains poisonous carbon monoxide. Never run the

generator in an enclosed area.

Be sure to provide adequate ventilation.

■ The muffler becomes very hot during operation and remains hot for

several minutes after stopping the engine.

Be careful not to touch the muffler while it is hot.

Let the engine cool before storing the generator indoors.

■ The engine exhaust system will be heated during operation and

remain hot immediately after stopping the engine.

To prevent scalding, pay attention to the warning marks attached to

the generator.

■ Gasoline is extremely flammable and explosive under certain conditions. Refuel in a well

ventilated area with the engine stopped.

■ Keep away from smoking materials, sparks and other sources of combustion when refueling

the generator. Always refuel in a well-ventilated location.

■ Wipe up spilled gasoline immediately.

.

5

■ Always make a pre-operation inspection before you start the engine. You may prevent an

accident or equipment damage.

■ Place the generator at least three feet or one meter away from buildings or other equipment

during operation.

■ Operate the generator on a level surface to prevent fuel spillage or oil starvation.

■ Know how to stop the generator quickly and understand operation of all controls. Never

permit anyone to operate the generator without proper instructions.

■ Keep children and pets away from the generator when it is in operation.

■ Keep away from rotating parts while the generator is running.

■ The generator is a potential source of electrical shock when misused; do not operate with wet

hands.

■ Do not operate the generator in rain or snow and do not let it get wet.

6

2. SAFETY LABEL LOCATIONS

These labels warn you potential hazards that can cause serious injury. Read the labels and safety

notes and precautions described in manual carefully.

If a label comes off or becomes hard to read, contact your dealer for a replacement.

3. COMPONENT IDENTIFICATION

CHOKE LEVER

LOW OIL ALARM

ENGINE SWITCH

HOT CAUTION
SAFETY CAUTION

MODEL

7

FUEL CAP VENT LEVER (Non CARB)

CHOKE LEVER

MAINTENANCE
COVER

STARTER GRIP

ENGINE SWITCH

TYPICALCONTROL
PANEL

FUEL FILLER CAP

SPARK PLUG
MAINTENANCE
COVER

MUFFLER

AIR INTAKE
AIR EXHAUST

8

Control panel

Parallel Control Panel

Smart throttle
switch

DC receptacle

Ground terminal

AC receptacle

overload protector

Parallel Receptacles

Low oil alarm

indicator light

overload indicator

light

output indicator
light

Smart throttle
switch

DC receptacle

Ground terminal

AC receptacle

overload protector

Low oil alarm

indicator light

overload indicator
light

output indicator
light

Overload reset switch

Overload reset switch

9

Serial number identification and location

The generator serial number identifies your particular unit and is important when ordering parts
and accessories. The number is found on a sticker on the carton and on the quality certificate in
the carton along with the accessories and owner’s manual. It is also stamped on the engine block
visible when the service door is removed.

IG1000: to the right of the engine oil dipstick IG2000: above right of the dipstick

IG2600: to the left of the engine oil dipstick

Please record this information below and keep this manual in a safe place along with the bill of
sale.

Serial Number __________________________________

Date and Place of Purchase ______________________________________________________

10

4. PRE-OPERATION CHECK

■ Be sure to check the generator on a level surface with the engine stopped.

1. Check the engine oil level.

■ Using non detergent oil or 2 cycle engine oil could shorten the engine's service life.

Use a high-detergent, premium quality 4-stroke engine oil, certified to meet or exceed U.S.

automobile manufacturer's requirements for API Service Classification SG/SF. Select the

appropriate viscosity for the average temperature in your area.

SAE Viscosity Grades

AMBIENT TEMPERATURE

Loosen the cover screw and remove the left side maintenance cover. Remove the oil filler cap,

and wipe the dipstick with a clean rag. Check the oil level by inserting the dipstick in the filler hole

without screwing it in.

If the oil level is below the end of the dipstick, refill the recommended oil up to the top of the oil

filler neck.

■ Running the engine with insufficient oil can cause serious engine damage.

Single

Viscosity

Multi-

viscosity

11

NOTE: The Low Oil Alarm System will automatically stop the engine before the oil level falls

below the safe limit. However, to avoid the inconvenience of an unexpected shutdown, it is still

advisable to visually inspect the oil level regularly.

You must screw down the dipstick completely to measure the oil level.

2. Check the fuel level.

Use automotive unleaded regular gasoline only. A fuel preservative and stabilizer should be

added to any container of stored fuel.

If the fuel level is low, refill the fuel tank until the level reaches the specified mark.

Never use an oil/gasoline mixture or dirty gasoline.

Avoid getting dirt, dust or water in the fuel tank.

After refueling, tighten the fuel filler cap securely.

■ Gasoline is extremely flammable and is explosive under certain conditions.

■ Refuel in a well-ventilated area with the engine stopped. Keep all smoking materials, sparks,

and any other source of combustion away from the generator during refueling.

■ Do not overfill the fuel tank (there should be no fuel above the upper limit mark). After

refueling, make sure the tank cap is closed properly and securely.

■ Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite, If any fuel is

spilled, make sure the area is dry before starting the engine.

■ Avoid repeated or prolonged contact with skin or breathing of vapor. KEEP OUT OF REACH

OF CHILDREN.

Oil gauge

Oil FILLER HOLE

UPPER LEVEL

UPPER LEVEL

UPPER LEVEL

12

Gasoline containing alternate fuels

If you decide to use a gasoline containing ethanol, be sure its octane rating is no lower than the

specification. Do not use a blend that contains more than 10% ethanol. Do not use gasoline

containing methanol.

■ Fuel system damage or engine performance problems resulting from the use of fuels that

contain an improper alcohol blend are not covered under warranty.

■ Before buying fuel from an unfamiliar station, Determine if the fuel contains ethanol and if it

does, confirm the type and percentage of ethanol used. If you notice any undesirable

operating symptoms while using a gasoline that contains ethanol, or one that you think

contains ethanol, replace it by a gasoline that you know has the proper blend.

13

3. Check the air cleaner

Check the air cleaner element to be sure it is clean and in good condition.

Loosen the cover screw and remove the left side maintenance cover.

Press the latch tab on the top of the air cleaner body, remove the air cleaner cover, check the

element. Clean or replace the element if necessary.

■ Never run the engine without the air cleaner. Rapid engine wear will result from contaminants,

such as dust and dirt, being drawn through the carburetor, into the engine.

CARBON CANISTER

MAINTENANCE COVER

MAINTENANCE COVER
SCREW

AIR CLEANER BODY

AIR CLEANER COVER

AIR CLEANER
COVER SCREW

AIR CLEANER ELEMENTS

14

5. STARTING THE ENGINE

Before starting the engine, disconnect any load from the AC receptacle.

1. Turn the engine switch to the ON position.

2. Move the choke lever to the START position.

NOTE:

Do not use the choke when the engine is warm or the ambient air temperature is high.

3. Pull the starter grip until resistance is felt then pull the starter grip briskly toward the

arrow as shown below.

ON

OFF
ON

ENGINE SWITCH

CHOKE LEVER

START

START

15

■ Do not allow the starter grip to snap back. Return it slowly by hand.

4. Move the choke lever to the RUN position after the engine warms up.

■ If the engine stops and will not restart, check the engine oil level before further

troubleshooting.

STARTER GRIP

CHOKE LEVER

RUN

RUN

16

6. GENERATOR USE

Be sure to ground the generator when loads are connected.

■ To prevent electrical shock from faulty appliances, the generator should be grounded.

Connect a length of heavy cable between the generator's ground terminal and an external

ground source.

■ Connections for standby power to a building's electrical system must be made by a qualified

electrician and must comply with all applicable laws and electrical codes. Improper

connections can allow electrical current from the generator to back feed into the utility lines.

Such back feed may electrocute utility company workers or others who contact the lines

during a power outage. When utility power is restored the generator may explode, burn, or

cause fires in the building's electrical system.

■ Do not connect the generator to an automatic transfer device. Severe damage to the inverter

module may result.

GROUND MARK

GROUND TERMINAL