Kipor Sinemaster IG2600, Sinemaster IG2600h Operation Manual
SINEMASTER
DIGITAL INVERTER GENERATOR
IG2600
IG2600h
WUXI KIPOR POWER CO., LTD.
12. SKETCH MAP
IG2600h
IG2600h movement state IG2600h placed state
PREFACE
Thank you for purchasing our generators.
This manual covers operation and maintenance of the IG2600, IG2600h
generator.
All information in this publication is based on the latest product information
available at the time of approval for printing.
We reserve the right to make changes at any time without notice and without
incurring any obligation.
No part of this publication may be reproduced without written permission.
This manual should be considered a permanent part of the generator and should
remain with it if it is resold.
Pay special attention to statements preceded by the following words;
Failure to properly follow these precautions can result in
property damage, serious injury or DEATH!
Read all labels and the owner's manual before operating
this generator.
Operate only in well ventilated areas. Exhaust gas
contains poisonous carbon monoxide, and can be deadly.
Always stop engine before refueling. Wait 5 minutes
before restarting.
Check for spilled fuel or leaks. Clean and/or repair before
use.
Keep any sources of ignition away from fuel tank, at all
times.
Indicates a strong possibility of severe personal injury or
death if instructions are not followed.
Indicates a possibility of personal injury or equipment
damage if instructions are not followed.
NOTE: Gives helpful information.
If a problem should arise, or if you have any questions about the generator,
consult an authorized dealer.
Our generators are designed to give safe and dependable
service if operated according to instructions. Read and
understand the Owner's Manual before operating the generator. Failure to do so could result in personal injury or
equipment damage.
The illustration may vary according to the type.
WARNING
CAUTION
WARNING
WARNING
11. SPECIFICATIONS
DC output
DC voltage
Electric circuit breaker
No. of Phase
12V-8.3A
Available
Single phase
Model
IG2600/IG2600h
Rated frequency (Hz)
Rated voltage (V)
Rated current (A)
Rated speed (rpm)
Rated output (kVA)
Max output (kVA)
50
230
10
3600
2.3
2.6
60
240
9.6
Engine
Model Type
KG171
Type
Displacement (Bore Stroke)
Compression ratio
Rated power (kW)
Rated rotation speed (rpm)
Ignition system
Spark plug
Starting system
Fuel
Fuel consumption (g /kW.h)
Lube oil
Single cylinder, 4 stroke, vertical, air-cooled, OHV, gasoline engine
171ml (66 55mm)
8.5:1
3.5/3600
3600
T. C. I
R6-388
Recoil starter
Automotive unleaded gasoline
450
SAE 10W30 (above CC grade)
Fuel tank capacity (L)
Continuous running time (hr) (at rated output)
Noise level(zero load~ full load) [dB(A)/7m]
Overall dimension (L W H) [mm(in)]
4.8
2.5
58-63 *
Dry weight [kg(lbs)]
IG2600: 26 (57.2) IG2600h: 27.5 (60.5)
IG2600: 564 317 453(22.20 12.48 17.83)
IG2600h: 590 330 480 (23.23 12.99 18.90)
60
120
19.5
CONTENTS
1. Safety Instructions
2. Safety Label Locations
3. Component Indentificaction
4. Pre-operation Check
5. Starting the Engine
High altitude operation
6. Generator Use
7. Stopping the Engine
8. Maintenance
9. Transporting/Storage
10. Troubleshooting
11. Specifications
12. Sketch Map
1
3
4
7
10
12
13
21
23
29
31
33
34
*: The declared values shall consider uncertainties due to production variation and
measurement procedures.
Is the overload
indicator light ON?
Appliance does not operate:
Is the output indicator light ON?
NO
NO
YES
YES
YES
NO
Take the generator to an
authorized dealer.
Take the generator to an
authorized dealer.
Check the electrical appliance or equipment for any
defects.
Replace the electrical
appliance or equipment
Take the electrical appliance or equipment to an
electrical shop for repair
Push the reset button.
YES
No electricity at the DC receptacle:
Is DC circuit breaker tripped?
Take the generator to an
authorized dealer.
NO
1. SAFETY INSTRUCTIONS
WARNING
WARNING
WARNING
Exhaust gas contains poisonous carbon monoxide.
Never run the generator in an enclosed area.
The muffler becomes very hot during operation and
remains hot for a while after stopping the engine.
Be careful not to touch the muffler while it is hot.
Let the engine cool before storing the generator indoors.
The engine exhaust system will be heated during operation and remain hot immediately after stopping the
engine.
To prevent scalding, pay attention to the warning marks
attached to the generator.
Our generators are designed to give safe anddepend-
able service if operated according to instructions.
Read and understand the Owner's Manual before operating the generator. Failure to do so could result in
personal injury or equipment damage.
Be sure to provide adequate ventilation.
When installed in ventilated protection are to be
observed.
To ensure safe operation--
WARNING
WARNING
WARNING
Gasoline is extremely flammable and explosive under
certain conditions. Refuel in a well ventilated area with
the engine stopped.
Keep away from cigarette, smoke and sparks when re-
fueling the generator. Always refuel in a well-ventilated
location.
Wipe up spilled gasoline at once.
Connections for standby power to a building's electrical
system must be made by a qualified electrician and must
comply with all applicable laws and electrical codes. Improper connections can allow electrical current from the
generator to back feed into the utility lines. Such back
feed may electrocute utility company workers or others
who contact the lines during a power outage, and when
utility power is restored, the generator may explode,burn
or cause fires in the building's electrical system.
Always make a pre-operation inspection before you
start the engine. You may prevent an accident or
equipment damage.
Place the generator at least 1m(3ft) away from build-
ings or other equipment during operation.
Operate the generator on a level surface.
If the generator is tiled, fuel spillage may result.
Know how to stop the generator quickly and understand
operation of all the controls.Never permit anyone to operate the generator without proper instructions.
Keep children and pets away from the generator when
it is in operation.
Keep away from rotating parts while the generator is
running.
The generator is a potential source of electrical shocks
when misused; do not operate with wet hands.
Do not operate the generator in rain or snow and do not
let it get wet.
10.TROUBLESHOOTING
When the engine will not start:
Is there fuel in the tank?
Is the engine switch on?
YES
YES
YES
Is there enough oil in the engine?
Is there a spark from
the spark plug?
NO
NO
NO
NO
Refill the fuel tank.
Turn the engine switch on.
Add the recommended oil.
Still no
spark
Replace the
spark plug.
Take the generator to an
authorized dealer.
WARNING
If the engine still does not
start, take the generator to
an authorized dealer.
Be sure there is no spilled
fuel around the spark pulg.
Spilled fuel may ignite.
To check:
1)Remove the spark plug cap and clean
any dirt from around the spark plug.
2)Remove the spark plug and install the
spark plug in the plug cap.
3)Set the plug side electrode on the cylinder head to ground.
4)Pull the recoil starter, sparks should jump
across the gap.
Oil level
Choke lever
Engine switch
Model
Hot caution
Drain Screw
Starter Grip
2. SAFETY LABEL LOCATIONS
These lables warn you of potential hazards that can cause serious injury. Read
the labels and safety notes and precautions described in this manual carefully.
If a label comes off or becomes hard to read, contact you dealer for a replace ment.
a. Drain all gasoline from the fuel tank into an approved gasoline container.
b. Turn the engine switch ON, and loosen the carburetor drain screw and drain the
gasoline from the carburetor into a suitable container.
c. With the drain screw loosened remove the spark plug cap, and pull the starter grip
3 to 4 times to drain the gasoline from the fuel pump.
d. Turn the engine switch to the OFF position, and tighten the drain screw securely.
5.Slowly pull the starter grip until resistance is felt. At this point, the piston is coming
3. Change the engine oil.
4. Remove the spark plug and pour about a tablespoon of clean engine oil into the
cylinder.
Crank the engine several revolutions to distribute the oil, then reinstall the spark
plug.
up on its compression stroke and both the intake and exhaust valves are closed.
Storing the engine in this position will help to protect it from internal corrosion.
Safety caution
Loading...