Kinroad XT125T-17, XT150T-17, XT125T-18, XT150T-18, XT250T-17 User Manual

-1-

FOREWORD

：

Thanks for your purchasing this motorcycle.
With the help of this manual, you will learn the
correct procedures of operation and basic knowledge of
maintenance and trouble shooting of the motorcycle. It
presents all the basic knowledge of maintenance and
trouble shooting of the motorcycle. It presents all
the details of the performance of this motorcycle to
you and the vehicle will make your life more relaxed
and happier.
In case any picture does not agree with the vehicle
physically, the latter shall prevail.

CAUTION．NOTE and MAIN POINTS carry special mean-

ings and should be carefully reviewed．

!CAUTION：The personal safety of the rider may be

involved，disregarding this information could result in
injury to the rider．

NOTE：These instructions point out special service

procedures or precautions that must be followed to
avoid damaging the machine．

MAIN POINTS ： This provides special information to make

maintenance easier orimportant instructions clear er．

VIN AND ENGINE SERIAL NUMBER LOCATION

The VIN and/or engine serial number are used to

register the motorcycle ． They are also use to assist

your dealer when ordering parts or special service
information.

The VIN is stamped on the front main beam of the
frame．
The engine serial number is stamped on the rear end

of the crankcase assembly

VIN. :

-2-

Engine No.:

CONTENTS

NOTES FOR SAFE RIDING……………………………2

LOCATION OF PARTS…………………………… …4

INSTRUMENT PANEL…………………………… ……7

USING METHODS OF SWITCHES……… ……………8

USING METHODS OF TRUNK…………………………10

ADD GASOLINE AND ENGINE OIL……………………11

CORRECT DRIVING OPERATIONS……………………12

INSPECTION BEFORE RIDING………………………20

PERIODICAL INSPECTIONS…………………………23

SIMPLE MAINTENANCE METHODS …………… … 26

SPECIFICATIONS……………………………… … 30

ELECTRICAL DIAGRAM……………………… ……31

NOTESFO R SAFE RIDING

RIDING APPAREL

1.Loose，fancy clothing can be uncomfortable and unsafe
when riding your motorcycle ． Choose good quality
motorcycle riding apparel when riding your motorcycle．

2. most motorcycle accident fatalities are due to head
injuries. ALWAYS wear a helmet, a face shield or
goggles as well as boots, gloves and protective
clothing. so does the passenger on your motorcycle.

3. the exhaust system must be very hot while you are
riding, and even remains so after the engine operation
stops, so never
touch any part
of the hot exhau
st

RULES FOR SAFE DRIVE

Check must

-3-

be conducted before starting the engine to prevent
mishaps and damage to components.

Only the qualified person who has passed the drive
examination with a drive license is permitted to drive
the vehicle but not anybody else without a drive license.

Full preoccupation is required during drive, paying
attention to the following points to avoid any possible
hurt to you by other motorized vehicles:

Do not drive too close to other vehicles;

Never contend for lane.

Strictly observe the local traffic rules.

As driving at overspeed is the cause of many
accidents. Do not drive at a speed that the actual
situation does not permit.

Particular care should be exercised at the level
crossing of roads, entrance and exit of parking lot or
on the automobile lane.

During drive, grasp the left handlebar by the left
hand and the throttle twist grip by the right hand, with
feet on
the footrests.

MODIFICATION

any modification of the motorcycle or removal of the
original equipment may render the vehicle unsafe or
illegal
P1ease obey all the national and local equipment
regulations.

DO NOT OVERLOAD

1. Do not load on the places where they are not allowed．

2.Do not put cotton or other same items near the
engine or the exhaust pipe, When the motorcycle is in
the over-loading condition, its stability, security and
speed will be affected.

-4-

LOCATIONOF PARTS

-5-

-6-

1.Ignition switch/stolen-prevention lock

2.Electric starter switch

3.Lamp switch

4.Handlebar

5.Front brake lever

6.Right mirror

7.Voltage indicator

8.The turn signals

9. speedometer
lO.Fuel level indicator

11.Left mirror

12.Switch to change the far and near light

13.Rear brake lever
l4.Turn signals switch

15.Horn button

-7-

INSTRUMENTPANEL

HOW TO USE THE INSTRUMENT PANEL

①SPE

EDOMETER

The speedometer indicates the road speed in
kilometers per hour.

②ODOMETER

The odometer registers the total distance that the
motorcycle has been run (The minimum number is
O．1km)You should change the engine oil and check the
motorcycle periodically according to it．

③FUEL GAUGE

The‘‘E’’mark ind icates the fuel tan k is empty or

nearly so．

MAINPOINTS

1. The indicator will stop at E position when
the ignition switch is turned to OFF
position.

2. place the motorcycle on the center stand to
read the number of the left fuel.

④THE TURN SIGNALS

Turn the switch to“LEFT”or“RIGHT”position，the

turn signal will flash to advise the driver．

⑤THE FAR LIGHT INDICATOR

The indicator will be lit when the change light

switch turned to FAR LIGHT position．

-8-

USINGMETHODS OF THE SWITCHES

THE IGNITION SWITCH

The ignition switch control the start，the wiring

diagram for lights and the lock for the handlebars．

Please take the key with you when yon leave your
motorcycle．
(ON)it is connected．

1.You can start the engine．

2.You can drive

3.You can not take the key down

(OFF)it is shut down．
1·You can not start the engine．
2·The engine is stopped．
3·You can take the key down or put the key in .
(LOCK)it is locked．

1.The handlebar are 1ocked ， you cannot change
directions．

2.You can take the key down or put the key in.

THE KEY TO THE HANDLE BARS

Please lock the handlebar lock when you 1eave the

motorcycle to avoid to avoid to be stolen．

(1)turn the handlebar to the left
(2)put the key in from OFF position，press and turn

to LOCK position．

(3)take the key down．

Do not press when you want to open the lock, it
will be all right to turn the key，from LOCK position
to OFF Position.

-9-

MAINPOINTS

1.If it is hard to lock，you can turn the handlebar

to the right a little and then lock it.

2.Shake the handlebars left and right to be sure

that it has been locked.

THE TURN SIGNALS

Use the turn signals when you want to turn to the

1eft or the right．

R：the right turn signal will flash．
L：the left turn signal will flash．

MIDDLE：the turn signal will not flash．

After you have finished， please turn off the turn
signals．

THE HORN BUTTON

Press the horn button，the horn will loud.

MAIN POINTS

Do not use the horn if un- necessary.

THE CHANGEABLE SWITCH FOR

THE FRONT LIGHT

Use this switch，you can change the light direction
of the front lamp．
HI：the high beam
LO：the low beam

MAIN POINTS

When there are cars before you or coming towards
you in the night, please use the LO switch．

THE START SWITCH

This Switch is to start the engine

Turn the switch to ON position and squeeze the
brake lever ． meanwhile press the starting button and
the engine will be started．

-10-

NOTE

If the engine call not be started in 3 seconds,
please use the kick starter to stare the engine to
avoid emptying the battery. Then check the starting
system.

THE FRONT LAMP SWITCH

Light switch

The front light switch has three positions,

And “●”(a white point).

When the switch is in this position, the
front head light ,tail and meter lights are
all lit up.
When the switch is in this position,the tail,

betraying and meter Lights are lit up.
“ ● ”When it is in this position. The front
illuminator, tail, betraying and meter lights are all
off.

OPEN THE TRUNK

Open the seat when you want use the trunk or put

the helmet in it.

1.put the ignition key in the lock of the seat and

turn to the right.

2.Hold the seat from the back up and open the seat.

3.Press the seat and the lock will be closed auto-

matically.

MAINPOINTS

After the engine is started by pressing the
ignition switch, you can inspect the wiring diagram
for the lights.

USIN
G
MET

HODSOF THE TRUNK

NOTE

1.H
old the
seat up
slightl
yto

-11-

see if the lock is closed.

2.If you press the seat when the ignition key in

the trunk, you can not take the key out, so please pay

much attention to this.

3.Do not keep such items as cotton on any place

under the seat except the trunk.

MAINPOINTS

1.The trunk load capacity is 10kg．

2.Do not keep heat- Sensitive item in trunk when

the trunk may get hot．

3.Do not keep valuable and easily damaged items in

the trunk．

4.Keep the easily—flown items first in the

plastic bag then put them in the trunk.

5.Do not allow water to get inside when the

washing the motorcycle．

6.Do not clean the trunk with water.

ADD GASOLINE ANDENGINEOIL

ADD GASOLINE

There is a gasoline tank gate at the rear part of
the seat，open it with the ignition key , take down the
cover．add unleaded gasoline with an octane rating of
90 or higher.

ENGINE OIL

There are several reasonable effects included in
the engine oil with high quality ． only the high
degreasing 4-strokeSAEl0W-30(SIGMA)engine oil can
ensure this requirement or even exceed it．Do not need
to use other additives．Yon can use the HQB-10 engine
oil instead according to the condition of our
marketing service．

Mucosity ： The mucosity of engine oil is to be
decided according to the humidity of local climate．