Kinroad XT125-19, XT200-19, XT250-16, XT125GY, XT200GY Instruction Manual

1

Ⅰ.SAFE DRIVE

Rules for Safe Drive
Check must be conducted,bef ore starting the engine,to prevent mishaps and damage to components.

Only the qualified person who has passed the drive examination with a drive license is permitted to drive the

vehicle but not anybody else without a drive license.

Full preoccupation is required during drive, paying attention to the following points to avoid any possible

hurt to you by other motorized vehicles:

Do not drive too close to other vehicles;
Never contend for lane.
Strictly observe the local traffic rules.
As driving at overspeed is the cause of many accidents. Do not drive at a speed that the actual situation does

not permit.

Particular care should be exercised at the level crossing of roads, entrance and exit of parking lot or on the

autonobile lane.

During drive, grasp the left handlebar by the left hand and the throttle twist grip by the right hand,with feet

on the footrests.

2

Protective wear

1.Protective wear such as helmet with protective mask, dustproof glasses and gloves should be worn during

drive for the sake of personal safety.

2.Loose clothes are not suitable for motorcycle drive or ride as they may get caught on the operating lever

,kick ,footrest or wheel, resulting in danger.

Modification of the vehicle

Caution:

Any unauthorized modif ication of the vehicle or replacement of the original parts can not ensure driving
safety and is illicit. The user must observe the regulation s of the traffic conrtol authorities, We are no t responsible
for any vehic le with unauthorized modification.

3

Ⅱ.MAIN DATA

Item 50 type Item 50 type
Overall length 1910mm Cylinder bore x stroke

39×41.4

Overall width 760mm Compression ratio

8.8:1

Overall height 1140mm Output,max

2.0kw/7000r/min

Wheelbase 1260 mm Torque,max

2.2N.m/62500r/min

Dead weight 92kg Idling speed

1500r/min±100r/min

Payload 150kg Displacement of cylinder

49ml

Front wheel 3.25-18 Spark plug

A7TC

Rear wheel 3.00-16 Spark plug gap

0.6~0.8mm

Speed,max 45km/h

Gap of air valve

Inlake valve:0.05mm

Braking distance ≤7m(30km/h)

Exhaust valve:0.08mm

Climbability ≥18° Ground clearance

200mm

Capacity of gasoline

5.5L Ignition means

CDI

Transmission ratio
1 st gear 3.273 2nd gear 1.937 3rd gear 1.611
4th gear

1.350

5th gear

Final reduction 3.286

4

III.PARTS & SUBAS SEMBLIES

5

6

7

IV.OPERATION
Fuel Cock

1.Fuel filling

The capacity of thefuel tank is 4.5L.Leadless gasoline of
No.90or above or low-lead gasoline is required for the
motorcycle.To fuel the vehicle,support it by the main stand,
open the lock cover of the fuel tank and fill fuel through the
opening.

Operation of thefuel cock
ON:With the handle of the fuel cock to

“ON”position,the fuel circuit is through for fuel supply.

OFF:With the handle of the fuel cock fo “OFF”

position,the fuel circuit is cut off without supply.

RES: With the handle of the fuel cock to “RES” position, the
fuel is supplide from the reserve.(Note:The reserved fuel can

only be used when the normal supply is run
out,) In this case,refueling should be carried
out as soon as possible; for there is only
somel.0L of fuel reserve for use.

8

Engine Startin

g

Warning:Never startthe engine in a closed

p

lace orwarehouse orwarehouse asthe

exhausted

gas

from the vehicle contains toxic

carbon monoxide.

1.Se

t

the keyofthe ignition switch to

“ON”

p

osition.

2.Ascertain the neutral

p

osition,where it

should

b

edisplayed.

3.Ascertain the amount o

f

fuel in the tank,

4.Se

t

the fuel cockhandle to “ON”position.

★T

o

startacoldengine;

1.Pull u

p

the chokebarofthe carburetor(to

close the choke

)

.

2.Rotate the throttle twist

grip

by

1/8to

1/4turn.

3.Start the en

g

inebythe electric orthe kick

startin

g

system.

4.Sli

g

htlyturn the throttle twistgripto

increase the s

peedof

the engine so asto

war

m

upthe engine.

5.Turn the carbureto

r

chokebardownward

to full

yop

en the choke whenthe engine is

sufficientl

y

warmedup.

★Caution:

The engine can only be started after the
neutral position is ascertained.Otherwise
accident will happen.
Unnecessary idle running(especially at a
high speed) is harmful to the engine.

★ Procedures for stopping the engine:

1.Release the throttle twist grip to slow

down the engine.

2.Turn to the neutral position.

3.Se

t

the ignition switch keyto

“OFF”

p

osition.

4.Set the fuel cockhandle to “OFF”

position.

Switches on Right Handle bar