Kino Flo Flathead 80, BAL-422-120, CFX-4808, X16-25, BAL-422-230 Operation Manual

Operation Manual

Flathead 80 System

w/Foto-Flo Ballast

Flathead 80 System includes:

CFX-4808

Flathead Fixture

MTP-K81

Mounting plate

BAL-422-120 or
BAL-422-230

Foto-Flo 400 Ballast
X2

X16-25

4Bank Extension, 25ft.
X 2

2

Insert lamps into both lamp holders. Twist ¼ turn to make
electrical contact.

The gel frame is secured to the fixture by 4 spring-loaded pins. Align the
pins of the gel frame with the oval receptacle holes on the edge of the
fixture. Pull back the pins and release into the receptacles to properly
secure the gel frame.

3

(A) (B)

A) The Gel Frame comes with

Gel Clips. Cut the gel to size and
use the Clips to fasten the gel to
the Frame.

B) Another method is to apply
transfer tape directly to the gel
frame. The clips are not
necessary when taping the gel.

Place the long edge of the Louver into the lower channel containing a set of
leaf springs. Press down on the Louver and slip the upper edge of the
louver into the upper channel of the fixture. To remove reverse the
procedure.

The Flathead 80 is designed to operate on a Junior stand,
hang from a Junior pipe hanger or mount directly to a set wall.

Mount Plate Operation

Align the center pin of the mounting
plate to the center hole on the mating
plate. Rotate plate clockwise until the
four shoulder rivets drop into the
receptacle. A locking pin will snap into
place when the plate is properly
seated.

To remove the plate, pull up on the
locking pin and reverse the mounting
procedure.

4