Kino Flo Trans-Flo User Manual

Operation Manual

Trans-Flo

A

The TRANS-FLO SYSTEM is a standard-output ballast that can
be dimmed on most common theatrical SCR dimming systems.
The modular design of the TRANS-FLO SYSTEM streamlines
set lighting installations, and its smooth dimming capability
ensures controlled lighting effects.

The TRANS-FLO Ballast can operate 15-inch, 2ft, 3ft and 4ft
lamps in pairs; two different sized lamps can be powered from
the same ballast. (Two lamps must be connected for the ballast
to operate.)

The POWER/DIM Cable provides primary voltage and dimming
control to the first TRANS-FLO Ballast. The Single Locking
Lamp Harnesses attach directly to each ballast, or they attach to
a ballast via a Head Extension ( up to 25ft long ).

Jumper Cables link TRANS-FLO Ballasts together ( up to 10 in
a series ).

The TRANS-FLO SYSTEM operates in three modes:

1. INDIVIDUAL BALLAST DIMMING MODE ( two
lamps )

2. SERIES BALLAST DIMMING MODE (up to 10
ballasts per series )

3. NON-DIM MODE

To operate, the TRANS-FLO SYSTEM in the Individual Ballast Dimming Mode
you need a minimum of:

TRANS-FLO Power & Dim
Cable, 6ft.

Primary power feed line and
dimming line ( both with
Edison connectors). One
cable per ballast is needed
for individual dimming
control.

TRANS FLO Two-Lamp
Ballast, 120 VAC

standard-output, flicker­free electronic dimming
ballast. Operates two 15­inch, 2ft, 3ft or 4ft lamps.

Lamp w/ Harness ( need
two per Ballast )

15-inch Med Bipin
2ft Med Bipin
3ft Med Bipin
4ft Med Bipin

2

3