Kino Flo tegra 4bank dmx Operation Manual

Operation Manual

Tegra 4Bank

DMX

Part No. 3100061 Rev A 11-03-2015

®

2

Tegra 4Bank DMX Assembly

True Match

Lamps

488-K32-S 4ft Kino KF32 Safety-Coated
488-K55-S 4ft Kino KF55 Safety-Coated

TEG-450-120U

Tegra 4Bank DMX, Univ 120U

TEG-450-230U

Tegra 4Bank DMX, Univ 230U

LVR-T490-P

Tegra 4Bank Louver/HP, 90°
(Included)

MTP-LB

Kino 41 Lollipop w/ Baby Receiver (16mm)
(Included)

®

3

Tegra 4Bank DMX Kits

Tegra 4Bank

DMX Kit

Tegra 4Bank DMX Kit

w/ Soft Case

KIT-T450-120U

Tegra 4Bank DMX Kit, Univ 120U

KIT-T450-230U

Tegra 4Bank DMX Kit, Univ 230U

Kit Contents:

1 Tegra 4Bank DMX
1 Flozier, Half
1 Lamp Case
1 Ship Case

Dimensions: Weight:

54.5 x 9 x 21” 41 lb
(138.5 x 23 x 53.5cm) (19kg)

KIT-T450B-120U

Tegra 4Bank DMX Kit w/ Soft Case,
Univ 120U

KIT-T450B-230U

Tegra 4Bank DMX Kit w/ Soft Case,
Univ 230U

Kit Contents:

1 Tegra 4Bank DMX
1 Flozier, Half
1 Lamp Case
1 Soft Case

Dimensions: Weight:

55 x 8 x 19.5” 23 lb
(140 x 20.5 x 49.5cm) (10.5kg)

4

Inserting Lamps

Lamp Harness Color Codes

Applying Louver

Locking Lamp Connector:

Depress both tabs on lamp connector and apply to
lamp pins. Match the Harness color-codes at each

end of the lamp.

Push lamps into the xture’s Lamp Holder Clips.

The Louver is fastened to the reector with 4 Velcro straps.

The Harness wiring is color-coded. The same color-code must match at
each end of the lamp for proper operation.

5

Mounting Procedures

Baby Offset Arm

A 180 degree turn is all that is required to loosen the
mount for orientation.

To adjust the tension on the lock lever, pull handle
away from mount. This disengages the handle from the
screw mechanism and allows the lever to be reoriented.
You can also use a screwdriver to adjust the tension.
Pull back on handle and adjust screw.

Lollipops are interchangeable.

MTP-L Kino 41 Lollipop w/ 3/8” Pin (10mm)
MTP-LB Kino 41 Lollipop w/ Baby Receiver (16mm)
MTP-LBS Kino 41 Lollipop w/ Baby Receiver

Short (16mm)

Mounted on a baby stand Mounted to pipe grid

Note: When hanging in a
studio, loop a safety cord
through the strain-relief ring
provided on the back of the

xture.

The Baby Offset Arm (MTP-B41F) allows xtures to mount on the center of a
stand or can also be under slung from a baby stand to use as an up light.