Kino Flo Select DMX 4Bank Operation Manual

Operation Manual

Select DMX 4Bank

Part No. 3100023 Rev B 01-07-2008

2

4Bank

4Bank System consists of:

1 Fixture
1 Mounting Plate
1 Extension Cable
1 Select DMX 4Bank Ballast

CFX-4804 4ft 4Bank Fixture
CFX-2404 2ft 4Bank Fixture

MTP-K41 Mounting Plate w/ 3/8” Pin

X16-25 4Bank Extension, 25ft

BAL-450-120 Select/Dmx 4Bank Ballast,

120VAC

BAL-450-230 Select/Dmx 4Bank Ballast,

230VAC

3

The 4Bank fixture is comprised of a removable Louver,
Reflector, and Lamp Harness. The Louver and Reflector
are held in place with Velcro fasteners. The Lamp Harness
is secured by means of a ¼ turn fastener and two clips.

To Release the Lamp Harness

Remove the harness from 2 clips located under the reflector.
Rotate the ¼ turn fastener clockwise to release harness.

The lamps can operate independent
of the fixture allowing them to be
built into sets or custom soft boxes
or hand held as a single tube for an

eye-light

.

WARNING: Always use safety coated

lamps to avoid injury if lamp breaks.

4

Locking Lamp Connector:

Depress both tabs on lamp connector and apply to lamp pins.
Match the Harness color-codes at each end of the lamp.

Push lamps into the fixture’s Lamp Holder Clips.

Lamp Harness Color Codes

The Harness wiring is color-coded. The same color­code must match at each end of the lamp for proper
operation.

RED
YELLOW
BLACK
BLUE

4Bank Harness

5

Align the center pin of the
mounting plate to the center
hole on the mating plate.

Rotate plate clockwise until the
four shoulder rivets drop into
the receptacle. A locking pin
will snap into place when the
plate is properly seated.

Restricting the airflow around the lamps can cause the lamp to
operate hotter. This increased heat will raise the lamp’s color
temperature and green spike. Therefore, it is recommended to
clip gels to the Doors of the Fixture.

Do Not clip gels to louver.
Do Not block the fixture ends in a manner that restricts airflow.

6

Optional Lollipops
w/ Baby Receivers
allow mounting to
a 5/8” pin or a
baby stand.

To remove the plate, pull up on
the locking pin and rotate the
plate counter clockwise.

The standard mount comes with
a 3/8” Lollipop that clamps into a

grip head.

The ball and socket
mount allows the fixture to be
oriented in a broad range of
angles.

The yellow wire loops provide
attachment points for a safety
chain.

The grommet
holes along
the edge of
the fixture
are designed
to allow the
fixture to be
screwed onto
set walls.

MTP-LB MTP-LBT