Kino Flo ParaZip 415 DMX, ParaZip 215 DMX Operation Manual
ParaZip 415 & 215 DMX
Operation Manual
Part No. 3100081 Rev A 06-15-2015
®
ParaZip 415 Yoke Mount
ParaZip 415 Pole-Op
ParaZip Fixture Styles and Features
ParaZip Yoke Mount
ParaZip Pole-Op
ZIP-415-120U
ParaZip 415 DMX Yoke Mount, Univ 120U
ZIP-415-230U
ParaZip 415 DMX Yoke Mount, Univ 230U
ZIP-415P-120U
ParaZip 415 DMX Pole-Op, Univ 120U
ZIP-415P-230U
ParaZip 415 DMX Pole-Op, Univ 230U
ZIP-215-120U
ParaZip 215 DMX Yoke Mount, Univ 120U
ZIP-215-230U
ParaZip 215 DMX Yoke Mount, Univ 230U
ZIP-215P-120U
ParaZip 215 DMX Pole-Op, Univ 120U
ZIP-215P-230U
ParaZip 215 DMX Pole-Op, Univ 230U
2
Included w/ all ParaZip Models
GFR-Z4
ParaZip 415 Gel Frame (Included)
GFR-Z2
ParaZip 215 Gel Frame (Included)
LVR-Z490-P
ParaZip 415 Louver/HP, 90° (Included)
LVR-Z290-P
ParaZip 215 Louver/HP, 90° (Included)
3
True Match Lamps
55C-K32 55W Kino KF32 Compact
55C-K55 55W Kino KF55 Compact
®
4
Inserting Gel Frame
Inserting Lamps
Remove gel frame. Insert lamp tip rst.
Snap lamp base into
lamp connector.
Remove the lamp base
cover by pulling up on the
two push-buttons.
The Gel Frame is secured to the xture by 4 spring-loaded pins. Align the pins of the
Gel Frame with the oval receptacle holes on the edge of the xture. Pull back the pins and
release into the receptacles to properly secure the Gel Frame.
To release lamps,
press red button and lift
lamp base out.
Replace lamp base cover
and push down on pins to
lock.
5
Inserting Louver
Mounting Barndoors
Applying Gel to Frame
A
B
A) The Gel Frame comes
with Gel Clips. Cut the gel
to size and use the clips to
fasten the gel to the frame.
B) Another method is to
apply transfer tape directly
to the gel frame. The clips
are not necessary when
taping the gel.
Place the long edge of the Louver into the lower channel containing a set of leaf springs.
Press down on the Louver and slip the upper edge of the louver into the upper channel of
the xture. Honeycomb louvers have tabs on the side to enable easy handling. To remove,
reverse the procedure.
Adjust the door tension with
a Phillips screwdriver.
Attach the Barndoors (sold separately) to the two receptacles
located along the top and bottom edge of the xture.
Loading...