Kino Flo Mega Single User Manual

Operation Manual

Mega Double & Single

Part No. 3100059 Rev A 09-18-2013

Mega Double System

CFX-9602 8ft Mega Double Fixture

CFX-7202 6ft Mega Double Fixture

MTP-KM Kino 81 “Slide-On” Mount w/

Junior Pin (28mm)

X09-25M Mega Double Extension, 25ft

BAL-215-M120 Mega Double Ballast,

120VAC

BAL-215-M230 Mega Double Ballast,
230VAC

2

Mega Single System

CFX-9601 8ft Mega Single Fixture

CFX-7201 6ft Mega Single Fixture

MTP-KM Kino 81 “Slide-On” Mount w/

Junior Pin (28mm)

X07-25M Mega Single Extension, 25ft

BAL-105-M120 Mega Single Ballast,

120VAC

BAL-115-M230 Mega Single Ballast,
230VAC

Each System consists of:

1 Mega Fixture
1 Mounting Plate
1 Extension Cable
1 Electronic Ballast

True Match Lamps

722-K32-S 6ft Kino KF32
722-K55-S 6ft Kino KF55

962-K32-S 8ft Kino KF32
962-K55-S 8ft Kino KF55

®

3

Fixture Assembly

(x2)

The Mega Double and Single xtures are comprised of two removable Louvers,
a Reector and a Lamp Harness. The Louvers and Reector are held in place with
Velcro fasteners. The Lamp Harness is secured by means of a ¼ turn fastener and
two clips.

Note: The 8ft xtures include two 4ft louvers; the 6ft xtures include two 3ft louvers.

To Release the Lamp Harness

Remove the harness from 2 clips located under the reector. Rotate the ¼ turn
fastener clockwise to release harness.

The lamps can operate independent of the xture allowing them to

be built into sets or custom soft boxes or hand-held as a single tube

for an eye-light.

WARNING: Always use safety-coated lamps to avoid injury if lamp

breaks.

Lamp Harness Color Codes

Red

Yellow

Double Harness

The Mega Double Harness wiring is color-coded. The same color-code must match at
each end of the lamp for proper operation.

4

Inserting Lamps

Locking Lamp Connector:

Depress both tabs on lamp connector and apply to lamp pins. Match the Harness
color-codes at each end of the lamp. Push lamps into the xture’s Lamp Holder Clips.

Note: Mega 4Bank xture is shown for example purposes only.

Gelling the Fixture

Restricting the airow around the lamps can cause the lamps to operate hotter.
This increased heat will raise the lamp’s color temperature and green spike.
Therefore, it is recommended to clip gels to the doors of the xture.

Remove louvers. Do Not clip gels to louver. Do Not block the xture ends in a
manner that restricts airow.

5