Kino Flo Foto-Flo 400 User Manual
Operation Manual
Foto-Flo 400
Part No. 3100007 Rev B 01-07-2008
..
KIT-F4-120
Foto-Flo 400 Kit, 120vac
KIT-F4-230
Foto-Flo 400 Kit, 230vac
Kit Contents:
1 Foto-Flo 400 Ballast
1 Foto-Flo 400 Fixture
1 Extension, 25ft
1 6-Lamp Carry Case
1 Travel Case
Dimensions Weight
54 x 21.5 x 9” 43lb
(137 x 54.5 x 23cm) (19.4kg)
2
CFX-F4
Foto-Flo 400 Fixture
MTP-B41
Mount w/ Baby Receiver
(16mm)
X16-25
Extension, 25ft
X16-12
Extension, 12ft
BAL-422-120
Foto-Flo 400 Ballast, 120vac
BAL-422-230
Foto-Flo 400 Ballast, 230vac
Each System consists of:
1 Foto-Flo 400 Fixture
1 Mounting Plate
1 25ft Extension Cable
1 Foto-Flo 400 Ballast
3
The Foto-Flo 400 fixture is comprised of a removable Louver,
Reflector, and Lamp Harness. The Louver and Reflector are
held in place with Velcro fasteners. The Lamp Harness is
secured by means of a ¼ turn fastener and two clips.
To Release the Lamp Harness
Remove the harness from 2 clips located under the reflector.
Rotate the ¼ turn fastener clockwise to release harness.
The lamps can operate independent
of the fixture allowing them to be
built into sets or custom soft boxes
or hand held as a single tube for an
eye-light
WARNING: Always use safety coated
lamps to avoid injury if lamp breaks.
.
4
W
Lamp Harness Color Codes
BLACK/RED
WHITE/YELLO
WHITE/BLACK
BLACK/BLUE
Foto-Flo 400 Harness
The Harness wiring is color-coded. The same colorcode must match at each end of the lamp for proper
operation.
Locking Lamp Connector:
Depress both tabs on lamp connector and apply to lamp pins.
Match the Harness color-codes at each end of the lamp.
Push lamps into the fixture’s Lamp Holder Clips.
5
Loading...