Kino Flo Blanket Light 6X6 User Manual
Operation Manual
Blanket-Lite 6 x 6
The Blanket-Lite 6x6 consists of sixteen 6ft high output lamps
powered by four Mega 4Bank ballasts. Lamps are spaced along two
ratchet straps on 4 ½ inch centers. The Blanket-Lite mounts onto a 6x6
pipe frame and works by itself or in conjunction with diffusion materials,
silver reflector or soft egg crate louver.
No Tools required for assembly.
BKT-6X6
Blanket-Lite 6X6
KAS-6X6
Blanket-Lite Case
BAL-410-M120
BAL-410-M230
Mega 4 Bank
Ballast x 4
FRM-6X6
Frame Assembly
REF 6X6
Silver Reflector
DFS-6X6
Silk Diffuser X2
X19-25M
25ft Mega 4 Bank
Extensions X 4
KAS-6X6F
Frame Case
KAS-4MB
Ballast Stand
Mount / Case
2
No tools are required to assemble the frame. Depress pins on the
frame corners and twist until they mate with holes in the Frame Pipe.
Once attached to the Pipe, Frame Corners should all be facing the
same way.
Frame Pipe
The Pipe Frame
Assembly consists of:
4 Frame Corners
4 Frame Pipes
12 Frame Clip Pins
2 Frame Ears
Frame
Corner
Frame Ear
Clamp the two frame ears
between the two arrows found
midway on the pipe frame.
Face in the same direction as
the frame corners.
The ears mount into a large
grip head on high roller stands
or other like stands.
Note: The locking knuckles
should be pointed to the
of the frame.
inside
3
The Blanket-Lite should travel with lamps
preloaded.
1) It is recommended to mount the
frame between two stands. Tilt
the top edge of the frame over
the open shipping case. Pull the
Blanket-Lite straps out of the box
leaving the Blanket-Lite in it’s
case.
2) Line up Blanket-Lite straps with
the black Velcro on the pipe
frame. Line up the straps’ red
line with the red arrow of the
tube. This ensures lamps are
evenly spaced out within the
pipe frame. Tighten loop down to
the pipe frame.
3) Tilt the frame up thereby lifting
the Blanket-Lite out from the
case.
4) Once the Blanket-Lite has
cleared the case, loop the straps
around the lower portion of the
pipe frame.
5) Hook the ratchet to the other end
of the strap.
4
6) Draw up any slack in
the strap and tighten by
drawing down the
ratchet lever until tight.
To give rigidity to the BlanketLite insert 4 pins through the
pipe frame into the two
horizontal Blanket-Lite harness
tubes.
One end of the harness tubes
require the pins to be inserted
through the strain relief disc.
Insert the remaining 8 pins at
90 degrees to the frame. These
pins support additional
accessories.
5
Loading...