Kino Flo BAL-450M User Manual

Operation Manual

MEGA 4Bank DMX

Part No. 3100033 Rev B 01-07-2008

MEGA 4Bank DMX

CFX-9604 8ft 4Bank Fixture
CFX-7204 6ft 4Bank Fixture

MTP-K81 Mega “Twist-On” Mount

w/ Junior Pin

X19-25M Mega 4Bank
Extension, 25ft

BAL-450-M120 Mega 4Bank

DMX Ballast, 120VAC

BAL-450-M230 Mega 4Bank

DMX Ballast, 230VAC

MEGA 4Bank DMX System consists of:

1 Fixture
1 Mounting Plate
1 Extension Cable
1 Mega 4Bank DMX Ballast

2

The 4Bank fixture is comprised of a removable Louver,
Reflector, and Lamp Harness. The Louver and Reflector
are held in place with Velcro fasteners. The Lamp Harness
is secured by means of a ¼ turn fastener and two clips.

To Release the Lamp Harness

Remove the harness from 2 clips located under the reflector.
Rotate the ¼ turn fastener clockwise to release harness.

The lamps can operate independent
of the fixture allowing them to be
built into sets or custom soft boxes
or hand held as a single tube for an

eye-light

WARNING: Always use safety coated

lamps to avoid injury if lamp breaks.

.

3

Lamp Harness Color Codes

RED
YELLOW
BLACK
BLUE

4Bank Harness

The Harness wiring is color-coded. The same color­code must match at each end of the lamp for proper
operation.

Locking Lamp Connector:

Depress both tabs on lamp connector and apply to lamp pins.
Match the Harness color-codes at each end of the lamp.
Push lamps into the fixture’s Lamp Holder Clips.

4

Restricting the airflow around the lamps can cause the lamp to
operate hotter. This increased heat will raise the lamp’s color
temperature and green spike. Therefore, it is recommended to
clip gels to the Doors of the Fixture.

Do Not clip gels to louver.
Do Not block the fixture ends in a manner that restricts airflow.

Mega 4Bank Mounting

Align the center pin of the Mounting
Plate (MTP-K81) to the center hole
on the mating plate. Rotate plate
clockwise until the four shoulder
rivets drop into the receptacle.
A locking pin will snap into place
when the plate is properly seated.

The Silver Loops provide
attachment points for a safety chain.

5

To remove the plate, pull up on the
locking pin and reverse the mounting
procedure.

To loosen or tighten the Lollipop
turn the Lock Lever. The Lever can be
adjusted so a 180° turn provides the
necessary clamping strength.
Reorienting the Lever allows for further
tightening or loosening of the clamp.

To reorient the Lock Lever, pull Lever
away from mount. This disengages the
Lever from the screw mechanism and
allows it to be reoriented.

Note: You can also use a screwdriver
to adjust the travel. Pull back on Lever
and adjust the screw in the center of
the Lever.

The grommet
holes along
the edge of
the fixture
are designed
to allow the
fixture to be
screwed onto
set walls.

6