Kino Flo 400-200 DMX User Manual
Operation Manual
ParaZip 400 & 200 DMX
®
ParaZip 400 Yoke Mount
ParaZip 400 Pole-Op
Part No. 3100039 Rev D 07-02-2012
ParaZip Fixture Styles and Features
ParaZip Yoke Mount
ParaZip Pole-Op
ZIP-400-120
ParaZip 400 DMX Yoke Mount, 120VAC
ZIP-400-230
ParaZip 400 DMX Yoke Mount, 230VAC
ZIP-200-120
ParaZip 200 DMX Yoke Mount, 120VAC
ZIP-200-230
ParaZip 200 DMX Yoke Mount, 230VAC
ZIP-400P-120
ParaZip 400 DMX Pole-Op, 120VAC
ZIP-400P-230
ParaZip 400 DMX Pole-Op, 230VAC
ZIP-200P-120
ParaZip 200 DMX Pole-Op, 120VAC
ZIP-200P-230
ParaZip 200 DMX Pole-Op, 230VAC
2
Included w/ all ParaZip Models
GFR-Z4
ParaZip 400 Gel Frame (Included)
GFR-Z2
ParaZip 200 Gel Frame (Included)
LVR-Z4-S
ParaZip 400 Silver Louver (Included)
LVR-Z2-S
ParaZip 200 Silver Louver (Included)
True Match Lamps
55C-K32 55W Kino KF32 Compact
55C-K55 55W Kino KF55 Compact
®
3
Inserting Lamps
Remove gel frame. Insert lamp tip rst.
Snap lamp base into
lamp connector.
Remove the lamp base
cover by pulling up on the
two push-buttons.
To release lamps,
press red button and lift
lamp base out.
Replace lamp base cover
and push down on pins to
lock.
Inserting Gel Frame
The Gel Frame is secured to the xture by 4 spring-loaded pins. Align the pins of the
Gel Frame with the oval receptacle holes on the edge of the xture. Pull back the pins and
release into the receptacles to properly secure the Gel Frame.
4
Applying Gel to Frame
A) The Gel Frame comes
with Gel Clips. Cut the gel
to size and use the clips to
fasten the gel to the frame.
B) Another method is to
apply transfer tape directly
to the gel frame. The clips
are not necessary when
A
B
taping the gel.
Inserting Louver
Place the long edge of the Louver into the lower channel containing a set of leaf springs.
Press down on the Louver and slip the upper edge of the louver into the upper channel of
the xture. Honeycomb louvers have tabs on the side to enable easy handling. To remove,
reverse the procedure.
Mounting Barndoors
Attach the Barndoors (sold separately) to the two receptacles
located along the top and bottom edge of the xture.
Adjust the door tension with
a Phillips screwdriver.
5
Loading...