Kingwave KW5229 User Manual

1.Contents:

1. One Camera

2. One 3dBi Antenna

3. One User Manual

2.Channel Selection

Each camera must be placed on a separate 5.8GHz wireless channel by
selecting the proper DIP switch configuration outlined in the table below. For
best results place wireless cameras on every other channel. For example,
for a typical wireless camera setup place camera one on channel 1, camera
two on channel 3, camera three on channel 5, and so on. You can utilize up
to 7 channels.
There is a 4 lever DIP switch located inside the wireless camera. Please
unscrew the two screws located on the top of the camera casing and remove
the camera sun shield. To open the camera housing remove the two screws
on the left side of the camera casing that provide a weather proof seal.
Please be sure to properly tighten these cameras when reassembling the
camera after you are done.
Open the camera casing and locate the DIP switch seated behind the board
camera module and set the camera to one of the 7 available wireless
channels based on the DIP switch configuration listed in the table below.
Please configure the wireless receiver to the same wireless channel by
setting the same DIP switch settings as the camera you configured above.

Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna
or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.