King Technology FROG Leap Pool Wake-Up User Manual
OPERATIONAL INSTRUCTIONS
Pool Wake-Up!™
for Spring Openings
OR
Pool Hibernation
for Fall Closings
1. READY:
Start by
removing
contaminants
to keep
water crystal
clear.
FROG Leap™
Depth Charge™
1. FROG Leap™ Depth Charge™
Spring: After
balancing the
pool water
and inserting
a new FROG
Leap Anti-Bac
Mineral Pac
into the FROG Leap or POOL FROG System insert
FROG Leap Depth Charge using steps 1 through 8.
Winter: Before lowering the water level and discarding the used
FROG Leap Anti-Bac Mineral Pac insert FROG Leap Depth Charge
using steps 1 through 8.
2. SET:
Then set
your
initial
chlorine
level.
REVEILLE
3. GO:
Then
prevent
algae with
a 90-day
algae
protection
guarantee.
FROG Leap™
Reveille™
Water Balance Guidelines
pH: 7.2 – 7.8
Total Alkalinity: 60 – 120 ppm
Calcium Hardness: 150 – 400
Total Dissolved Solids: <1500
Stabilizer: 20 – 80 ppm
Free Chlorine: 0.5 – 1.0 ppm
A
L
FROG Leap™
ALL-OUT™
6. Remove the empty FROG Leap Depth Charge and
discard or recycle.
WE RECYCLE
All components are recyclable when finished dispensing.
7. Replace cap on FROG Leap or POOL FROG System
and allow circulation to run at least 15 minutes
™
I
N
F
U
Z
M
i
n
e
r
a
l
D
i
s
p
e
n
s
i
n
g
before inserting any other FROG Leap products.
R
E
m
e
t
s
y
S
8. Repeat steps 1-7 if additional FROG Leap Depth
Charge is required.
2. FROG Leap™ Reveille™
T
U
L
-
O
REVEILLE
Dispense FROG Leap Reveille to establish a chlorine
level in the pool following the same steps 1 through
8 for FROG Leap Depth Charge.
3. FROG Leap™ ALL-OUT™
After FROG Leap Depth Charge and FROG Leap Reveille have dispensed, test the water before adding FROG Leap ALL-OUT for a 90-day
algae protection guarantee.
details.)
When the pH is between 7.2 - 7.8 and the chlorine level is no
more than 4.0 ppm, follow steps 1-8 below:
1. Turn off pump and turn dial to the lowest setting
and remove cap from the FROG Leap or POOL FROG
System.
Y
9
A
0
D
2. Remove cap from FROG Leap ALL-OUT without
removing seal.
(See www.kingtechnology.com for guarantee
1. With the circulation system off, set control dial to
the lowest setting and remove the cap to the FROG
I
N
M
i
n
e
r
COLORED
CAPS
F
U
R
Z
E
a
l
D
m
i
s
e
p
t
e
s
n
y
s
i
S
n
g
Leap or POOL FROG System.
2. Remove caps from FROG Leap Depth Charge with a
pliers or other suitable tool.
3. Turn FROG Leap Depth Charge over so open ends
face down and insert into the center of the FROG Leap
Anti-Bac Mineral Pac. The ends of the pac will align
with an L-shaped key in the system. DO NOT FORCE.
4
4. Replace cap on FROG Leap or POOL FROG System
and set dial to Setting 5.
5. Turn on pump and allow 1 hour for the product to
1
HOUR
slowly dispense into the pool. If after 1 hour, the pac
still contains some ingredient, re-insert, replace cap
and run the circulation for an additional 30 minutes.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095; 6,948,510
and other U.S. and Foreign patents pending.
3. Insert upside down into center of FROG Leap
Anti-Bac Mineral Pac pushing down firmly on key to
puncture seal.
4
4. Replace cap by hand only. DO NOT OVER TIGHTEN.
Turn control dial to Setting 5.
90
MIN
5. Turn pump on for 90 minutes allowing FROG Leap
ALL-OUT to circulate through pool.
6. To remove FROG Leap ALL-OUT, turn pump off, turn
dial to lowest setting, remove system cap.
7. Lift FROG Leap ALL-OUT up and allow any water in
the container to drain through the system before
recycling or discarding in trash.
NOTE: If water shows more than a hint of blue inside
FROG Leap or POOL FROG System, replace the cap,
turn dial to Setting 5 and run the pump for one minute.
8. If pool size requires additional FROG Leap ALL-OUT,
repeat steps 1-7.
NOTE: Avoid adding other chemicals until this product has
been circulated (filtered) for at least 24 hours.
King Technology, Inc. 530 11th Ave S, Hopkins, MN 55343 www.kingtechnology.com
553081243N 20-48-0266
Loading...