KINGSUN MF210T Users Manual

User Manual of Wireless Earphone

1 Installation

Installation of receiver (Figure A)
Open battery case cover and place in two AAA batteries
Installation of transmitter (Figure B)
Connect transformer correctly
Connect lotus plug audio cable from “AUDIO OUT” socket of TV (or DVD, VCD)to audio input
socket for R& L channel of transmitter.
（Note: TV, DVD , VCD uses lotus plug）

Connect Stereo plug audio cable from headphone socket of iPod (or MP3, CD player) to audio
input socket of transmitter.（Note: volume of received sound is also determined by volume of iPod
(or MP3, CD player).

2 Operation Instructions

1) Turn power switch upwards to activate transmitter; the power light should be turned on.

2) Pull up receiver’s antenna, turn receiver’s power switch upward and volume tuner to your
desired position; the power light should be turned on.

3) Press RESET button and SELECT button to receive.

3 Radio receiving

1) Receiver can be used as FM radio receiver when used alone.

2) Turn upward to turn on receiver’s volume control, the power light should be turned on and

pull up receiver’s antenna.

3) Press button for radio / TV conversion.

4) Press RESET and then digital SELECT to automatically scan FM radio between 79MHz to
107MHz; one radio station will be scanned and locked for each time SELECT button is
pressed.

4 Using wired earphone

Receiver is supplied with an audio wire to use as a wired earphone.

Cautions:

If sound is too loud or distorted, please turn down source volume (TV or other products) to
improve receiving effects. Replace batteries when the following problems occur:
Power light is dim.
Receiver can barely receive sound.
Sound volume is low and distorted.
Turn off transmitter’s power supply after usage. (It is suggested to place transmitter at high
position for better signal receiving.)

Appearance and functions