Page 1
ASSEMBLY INSTRUCTION
E936-24 24"H COUNTER HEIGHT CHAIR
E936-29 29"H BAR HEIGHT CHAIR
Seat
A
1 pc 1 pc 1 pc1 pc
Back Support
E F
1 pc 4 pcs 8 pcs2 pcs
Lock Washer
I
Ø1/4"*13mm
B
J
Seat Frame
Bolt
Ø1/4"x1-1/2"
Flat Washer
Ø1/4"*16mm
Front Frame
C
Bolt
G
Ø1/4"x3/4"
Allen Key
K
M4
Stretcher
D
Bolt
H
Ø1/4"x5/8"
10 pcs 1 pc10 pcs
This page lists all the contents included in the box.
Please take the time to identify the hardware as
well as the individual components to this product.
As you unpack and prepare for assembly, place
the contents on a carpeted or padded area to
protect them from damage.
Page 2
Attach Seat Frame (B) to Front Frame (C), using Bolt (F) & Bolt (H), Lock Washer (I)
1
and Flat Washer (J) by Allen Key (K) as below shown.
Take the Allen Key, and turn the bolts
until the legs are secure.
DO NOT TIGHTEN COMPLETELY.
Stop when you feel you are adding
force to tighten the bolt.
Attach Back Support (E) to Stretcher (D), using Bolt (H) by Allen Key (K) as below
2
shown.
E
Page 3
Assembly pre-assembled two units together, using Bolt(H), Lock Washer (I) and Flat
3
Washer (J) by Allen Key (K) as below shown.
E
D
C
Attach Seat (A) to Seat frame (B), using Bolt (G), Lock Washer (I) and Flat
4
Washer (J) by Allen Key (K) as below shown.
Stand chair up on an
even surface and check
that it is balanced. If
there is a slight wobble,
apply downward
pressure in the corner
where a leg is uneven.
Keeping pressure in that
corner, tighten all bolts. If
balanced, apply
downward pressure
evenly in the center and
tighten all bolts.
Do not over-tighten
beyond hole depth.
B
A
Helpful Tip:
-Instead of applying downward
pressure while reaching under
to tighten bolts, have someone
sit in the chair while you tighten
the bolts.
B
Turn left or turn
right to adjust the
leveler until the
chair is stabilized.
K
G
I
J
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant.
Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware
may loosen over time.Periodically check that all connections are tight.
Loading...