Page 1
ASSEMBLY INSTRUCTION
883-T TV STAND WITH SHELVES
Table Top Support BarSide Frame
Shelf Support Bar
Table Top Stretcher
2PCS
Table Top
1PC
Bolt
1/4" x 55mm
6PCS
Strap
240 x
7mm
(Anti-Tipping Kit)
1PC
Screw
M4 x 15mm
(Anti-Tipping Kit)
2PCS
Shelf
2PCS
Bolt
1/4" x 43mm
8PCS
Plastic Bracket
43 x 20mm
(Anti-Tipping Kit)
2PCS
4PCS
Bolt
1/4" x 16mm
14PCS
Bolt
5/16" x 43mm
4PCS
Wall Anchor
M4
(Anti-Tipping Kit)
2PCS
2PCS
Bolt
1/4" x 35mm
12PCS
L-Allen Key
4mm
1PC
Screw
M4 x 30mm
(Anti-Tipping Kit)
2PCS
2PCS
This page lists all the contents included
in the box. Please take the time to
identify the hardware as well as the
individual components to this product.
As you unpack and prepare for
assembly, place the contents on a
carpeted or padded area to protect
them from damage.
1
Page 2
Attach the Side Frame (A) to
(C), insert the Bolt (K), Bolt (G) and Bolt (J), turn the L-Allen Key (L) to
Bar
Table
Top Support Bar (B) and
Shelf Support
tighten them.
Attach the
Table
L
A
Top Stretcher (D) to
K
C
B
G
A
A
B
Top Support Bar (B), insert the
B
C
C
C
C
J
Table
Bolt (G), turn the L-Allen Key (L) to tighten them.
B
D
G
L
D
B
D
B
Turn the assembled frame over as shown. Attach the Shelf (F) to Shelf
Support Bar (C), insert the Bolt (H), turn the L-Allen Key (L) to tighten them.
H
L
F
C
C
C
C
F
F
C
2
Page 3
Turn the assembled frame over as shown. Attach the Table Top (E) to Side
Frame (A) and Table Top Support Bar (B), insert the Bolt (G) and Bolt (I), turn
the L-Allen Key (L) to tighten them.
E
B
A
G
I
L
E
B
A
A
Drill two holes in the wall and insert the Wall Anchor (O) into the holes. Attach
the Plastic Bracket (N) to the back of the Table Top (E) using the Screw (Q)
and a Phillips Screwdriver (not provided). Then attach the other Plastic
Bracket (N) to the Wall Anchor (O) and the wall using Screw (P) and a Phillips
Screwdriver (not provided). Move the TV stand to its final position. Thread the
Strap (M) through each Plastic Bracket (N) and pull the Strap (M) tight as
shown.
Not Provided
WALL
P
O
N
Q
WALL
N
E
WALL
E
N
M
N
E
Cleaning & Care
Treat surfaces with care. Surfaces are resistant to scratches but are not scratch resistant. Clean surfaces
with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically
check that all connections are tight.
3
Loading...