Page 1
This page lists all the contents included in the box.
Please take the time to identify the hardware as well
as the individual components to this product. As you
unpack and prepare for assembly, place the contents
on the carpeted or padded area to protect them from
damage.
B2013 / B2043 / B2053 / B2063- 9(SPK) CHEST
Chest
1
Bracket
(Anti - Tipping HW)
1PC
Strap
(Anti - Tipping HW)
Screw
M4 X 50mm
(Anti - Tipping HW)
Screw
M4 X 15mm
(Anti - Tipping HW)
2PCS 1PC 1PC 1PC
ASSEMBLY INSTRUCTION
Page 2
2
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a
dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that
all connections are tight.
This tip restraint must be attached to a wall stud using the 2" Screw (E) enclosed.
1. Attach a Bracket (B) securely to the back top rail of the Chest (A) using the 5/8"
Screw (E) provided, through the smaller hole.
2. Locate the other Bracket (B) on the wall over a wall stud and 2 inches below the
bracket secured to the back of your unit. Attach to the wall stud using the 2"
Screw (D) provided through the smaller hole.
3. Place the furniture into position so both Brackets (B) are vertically in line.
4. Lace the end of the restraint Strap(C) through the larger hole in each bracket.
Bring both ends together and slide the flat end through the locking end and draw
it through until all slack is removed.
5. Confirm that the Strap (C) is securely laced and locked.
WALL
C
B
D
E
Loading...