Page 1
B C
D
E F
G
H
L
J
K
I
N
O
P
Q
R
M
A
ASSEMBLY INSTRUCTION
E739B HEADBOARD/FOOTBOARD W/CANOPY AND MATTRESS FRAME
Footboard support
2pcs 1pc 1pc
Footboard panel
Headboard - right support Headboard - left support
Side panel
Headboard stretcher
1pc 2pcs
Headboard - back support Mattress frame stretcher Canopy long stretcher
3pcs 3pcs 2pcs
2pcs 3pcs 1pc
1/2”L 42pcs 1-1/2”L 3pcs 1” L 6pcs
Canopy short stretcher Mattress frame support Upholstery
Bolt Bolt Bolt
Leveler
Flat washer Allen wrench
2pcs
3pcs 6pcs 1pc
This page lists all the contents included in the box.
Please take the time to identify the hardware as
well as the individual components to this product.
As you unpack and prepare for assembly, place
the contents on a carpeted or padded area to
protect them from damage.
1
Page 2
*** Do not tighten screws & bolts until the entire unit is completely assembled.
Please take note and follow the directions as the assemly instruction shown while assembing.
1
Attach footboard panel (D) and canopy short stretcher (J) to footboard support (A) using
bolts (M) and allen wrench (R) as shown.
Attach canopy short stretcher (J) and headboard stretcher (F) to headboard – right support (B)
2
and headboard -left support (C) using bolts (M) and allen wrench (R) again.
2
Page 3
Using bolts (M) and allen wrench (R), attach headboard – back support (G) to headboard
3
stretcher (F) as shown.
Attach side panel (E) to the assembled headboard and footboard using bolts (M) and allen
4
wrench (R) as shown.
3
Page 4
5
Using bolts (M) and allen wrench (R) again, attach canopy long stretcher (I) the
assembled headboard and footboard as shown.
6
Attach mattress frame support (K) to mattress frame stretcher (H) using bolts (N) and allen
wrench (R). Then, attach leveler (P) to mattress frame support (K).
Attach the assembled mattress frame stretcher (H) to side panel (E) using bolts (M) and allen
wrench (R) as shown.
4
Page 5
7
Please note the part of upholstery (L) is in a separate pack.
Attach upholstery (L) to headboard – back support (G) using flat washer (Q), bolts (O) and
allen wrench (R) as shown.
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or
damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all
connections are tight.
5
Loading...