Page 1
Memory Module Specifi cations
KVR21N15S8K2/8
8GB (4GB 1Rx8 512M x 64-Bit x 2 pcs.) PC4-2133
CL15 288-Pin DIMM Kit
DESCRIPTION
This document describes ValueRAM's KVR21N15S8K2/8 is a
kit of two 512M x 64-bit (4GB) DDR4-2133 CL15 SDRAM
(Synchronous DRAM), 1Rx8, memory modules, based on eight
512M x 8-bit FBGA components. Total kit capacity is 8GB. The
SPD is programmed to JEDEC standard latency DDR4-2133
timing of 15-15-15 at 1.2V. Each 288-pin DIMM uses gold
contact fingers. The electrical and mechanical specifications are
as follows:
FEATURES
• Power Supply: VDD=1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD=2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
*Power will vary depending on the SDRAM used.
15 cycles
46.5ns(min.)
260ns(min.)
33ns(min.)
TBD W*
94 V - 0
o
C to +85o C
0
o
C to +100o C
-55
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• PCB: Height 1.23” (31.25mm)
• RoHS Compliant and Halogen-Free
kingston.com
Continued >>
Document No. VALUERAM1482-001.A00 09/14/15 Page 1
Page 2
±
continued HyperX
MODULE DIMENSIONS
Front
3.00
Back
133.35
129.55
2.10
±±0.15
31.25
Detail A
Pin 1
0.15
3.35
2.70
28.90
Detail B Detail D Detail C
Pin 35 Pin 47
64.60
Detail E
Pin 105 Pin 117
56.10
22.95
11.00
8.00
17.60
14.60
kingston.com
Document No. VALUERAM1482-001.A00 Page 2
Loading...