Kingston KVR16R11D4-16 User Manual

Memory Module Specifi cations

KVR16R11D4/16

16GB 2Rx4 2G x 72-Bit PC3-12800
CL11 Registered w/Parity 240-Pin DIMM

DESCRIPTION

This document describes ValueRAM's 2G x 72-bit (16GB)
DDR3-1600 CL11 SDRAM (Synchronous DRAM), registered w/
parity, 2Rx4 ECC memory module, based on thirty-six
1G x 4-bit FBGA components. The SPD is programmed to
JEDEC standard latency DDR3-1600 timing of 11-11-11 at

1.5V. This 240-pin DIMM uses gold contact fingers. The
electrical and mechanical specifications are as follows:

FEATURES

• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 800MHz fCK for 1600Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]

SPECIFICATIONS

CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)

Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power 6.681 W*

UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C

*Power will vary depending on the SDRAM and
Register/PLL used.

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• On-DIMM thermal sensor (Grade B)

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• PCB : Height 1.180” (30.00mm), double sided component

Continued >>

Document No. VALUERAM1123-001.A00 04/25/12 Page 1

MODULE DIMENSIONS:

Document No. VALUERAM1123-001.A00 Page 2