Kingston KVR16N11-8 User Manual

Memory Module Specifi cations
KVR16N11/8
8GB 2Rx8 1G x 64-Bit PC3-12800 CL11 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 1G x 64-bit (8GB) DDR3­1600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
FEATURES
• JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 8000MHz fCK for 1600Mb/sec/pin
• 8 independent internal banks
• Programmable CAS latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS)
SPECIFICATIONS
CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh
Command Time (tRFCmin) Row Active Time (tRASmin) Maximum Operating Power UL Rating Operating Temperature Storage Temperature
*Power will vary depending on the SDRAM used.
11 cycles
48.125ns(min.) 260ns(min.)
35ns(min.) TBD W* 94 V - 0
o
C to +85o C
0
o
C to +100o C
-55
• Bi-directional Differential Data Strobe
• Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°Cº
• Asynchronous Reset
• PCB: Height 0.740” (18.75mm) or 1.180” (30.00mm)
Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here.
Continued >>
kingston.com
Document No. VALUERAM1445-001.B00 03/26/15 Page 1
MODULE DIMENSIONS
kingston.com
Document No. VALUERAM1445-001.B00 Page 2
Loading...