![](/html/83/83fe/83fe17f091d2c8de417c25a2eb57c1d087e5f67eff7e3bfe054f470e852b3eb9/bg1.png)
Memory Module Specifi cations
KVR16N11/4
4GB 2Rx8 512M x 64-Bit PC3-12800
CL11 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 512M x 64-bit (4GB)
DDR3-1600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory
module, based on sixteen 256M x 8-bit FBGA components. The
SPD is programmed to JEDEC standard latency DDR3-1600
timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold
contact fingers. The electrical and mechanical specifications
are as follows:
FEATURES
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
SPECIFICATIONS
CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 160ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power 2.580 W*
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component
Continued >>
Document No. VALUERAM1163-001.A00 04/30/12 Page 1
![](/html/83/83fe/83fe17f091d2c8de417c25a2eb57c1d087e5f67eff7e3bfe054f470e852b3eb9/bg2.png)
MODULE DIMENSIONS:
TECHNOLOGY
30.00
18.80
15.80
11.00
8.00
0.00
Units: millimeters
0.00
133.35
54.70
Document No. VALUERAM1163-001.A00 Page 2