Memory Module Specification
KVR1333D3S9/1GKF
1GB 128M x 64-Bit PC3-10600
CL9 204-Pin SODIMM
DESCRIPTION:
This document describes ValueRAM's 128M x 64-bit (1GB) DDR3-1333MHz CL9 SDRAM (Synchronous DRAM)
memory module, based on eight 128M x 8-bit DDR3-1333MHz FBGA components. The SPD is programmed to JEDEC
standard latency 1333MHz timing of 9-9-9 at 1.5V. This 204-pin SODIMM uses gold contact fingers and requires
+1.5V. The electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency (CWL) = 7 (DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal (self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component
PERFORMANCE:
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 110ns
Row Active Time (tRASmin) 36ns (min.)
Power 0.600 W (operating)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
DRAM SUPPORTED:
Kingston F-Die
Document No. VALUERAM0942-001.A00
12/06/10
Page 1
MODULE DIMENSIONS:
ValueRAM
(units = millimeters)
Document No. VALUERAM0942-001.A00 Page 2