Kingston KVR1333D3N9K33G User Manual

Memory Module Specification

KVR1333D3N9K3/3G

3GB (1GB 128M x 64-Bit x 3 pcs.) PC3-10600 Triple-Channel CL9 240-Pin DIMM Kit

DESCRIPTION:

ValueRAM's KVR1333D3N9K3/3G is a triple-channel kit of three 128M x 64-bit 1GB (1024MB) DDR3-1333 CL9 SDRAM (Synchronous DRAM) memory modules, based on eight 128M x 8-bit DDR3-1333 FBGA components per module. Total kit capacity is 3GB (3072MB). The SPDs are programmed to JEDEC standard latency 1333Mhz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

FEATURES:

JEDEC standard 1.5V ± 0.075V Power Supply VDDQ = 1.5V ± 0.075V

667MHz fCK for 1333Mb/sec/pin 8 independent internal bank

Programmable CAS Latency: 6,7,8,9 Posted CAS

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 9(DDR3-1333) 8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin

Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset

PCB : Height 1.180” (30.00mm), single sided component

PERFORMANCE:

	CL(IDD)	9 cycles

	Row Cycle Time (tRCmin)	49.5ns (min.)

	Refresh to Active/Refresh Command Time (tRFCmin)	110ns

	Row Active Time (tRASmin)	36ns (min.)

	Power	1.296 W (operating per module)

	UL Rating	94 V - 0

	Operating Temperature	0o C to 85o C

	Storage Temperature	-55o C to +100o C

Document No. VALUERAM0721-001.A00

10/28/08

Page 1

ValueRAM

MODULE DIMENSIONS:

T E C H N O L O G Y

30.00	Units: millimeters	133.35

18.80

15.80

11.00

8.00

0.00

54.70

Document No. VALUERAM0721-001.A00

Page 2