Kingston KVR1333D3N9K312G User Manual
Memory Module Specification
KVR1333D3N9K3/12G
12GB (4GB 512M x 64-Bit x 3 pcs.) PC3-10600
CL9 240-Pin DIMM Kit
DESCRIPTION:
ValueRAM's KVR1333D3N9K3/12G is a kit of three 512M x 64-bit 4GB (4096MB) DDR3-1333 CL9 SDRAM
(Synchronous DRAM) memory modules, based on sixteen 256M x 8-bit DDR3-1333 FBGA components per module.
Total kit capacity is 12GB. The SPDs are programmed to JEDEC standard latency 1333Mhz timing of 9-9-9 at 1.5V.
Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as
follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component
PERFORMANCE:
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 160ns
Row Active Time (tRASmin) 36ns (min.)
Power 1.380 W (operating per module)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
Document No. VALUERAM0845-001.A00
09/18/09
Page 1
MODULE DIMENSIONS:
ValueRAM
30.00
18.80
15.80
11.00
8.00
0.00
TECHNOLOGY
Units: millimeters
0.00
133.35
54.70
Document No. VALUERAM0845-001.A00 Page 2
Loading...