Kingston KVR1333D3N9-8G User Manual

Memory Module Specifi cations
KVR1333D3N9/8G
8GB 2Rx8 1G x 64-Bit PC3-10600 CL9 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 1G x 64-bit (8GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
8-bit pre-fetch
SPECIFICATIONS
selcyc 9)DDI(LC Row Cycle Time (tRCmin) 49.125ns (min.) Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin) Row Active Time (tRASmin) 36ns (min.) Maximum Operating Power TBD W*
0 - V 49gnitaR LU Operating Temperature 0 Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
o
C to 85o C
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE
< 95°C
Asynchronous Reset
PCB: Height 0.740” (18.75mm) or 1.180” (30.00mm)
Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here.
Continued >>
Document No. VALUERAM1031-001.C00 03/26/15 Page 1
MODULE DIMENSIONS:
Document No. VALUERAM1031-001.C00 Page 2
Loading...