Kingston KVR1333D3D8R9SK36GI User Manual

Memory Module Specification

KVR1333D3D8R9SK3/6GI

6GB (2GB 256M x 72-Bit x 3 pcs.) PC3-10600 CL9 Registered w/Parity 240-Pin DIMM Kit

DESCRIPTION:

ValueRAM's KVR1333D3D8R9SK3/6GI is a kit of three 256M x 72-bit 2GB (2048MB) DDR3-1333MHz CL9 SDRAM (Synchronous DRAM) registered w/parity, (Intel® Compatibility Tested), dual-rank memory modules, based on eighteen 128M x 8-bit DDR3-1333MHz FBGA components per module. Total kit capacity is 6GB (6144MB). The SPDs are programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

FEATURES:

JEDEC standard 1.5V ± 0.075V Power Supply VDDQ = 1.5V ± 0.075V

667MHz fCK for 1333Mb/sec/pin 8 independent internal bank

Programmable CAS Latency: 6,7,8,9,10

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 7(DDR3-1333) 8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin

On-DIMM thermal sensor (Grade B)

Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset

PCB : Height 1.180” (30.00mm), double sided component

PERFORMANCE:

	CL(IDD)	9 cycles
	Row Cycle Time (tRCmin)	49.5ns (min.)
	Refresh to Active/Refresh Command Time (tRFCmin)	110ns (min.)
	Row Active Time (tRASmin)	36ns (min.)
	Power	3.480 W (operating per module)
	UL Rating	94 V - 0
	Operating Temperature	0o C to 85o C
	Storage Temperature	-55o C to +100o C

Document No. VALUERAM0828-001.A00

08/03/09

Page 1

ValueRAM

MODULE DIMENSIONS:

(units = millimeters)

Document No. VALUERAM0828-001.A00

Page 2