Kingston KVR1333D3D4R9S-8G User Manual

Memory Module Specications

KVR1333D3D4R9S/8G

8GB 1024M x 72-Bit PC3-10600
CL9 Registered w/Parity 240-Pin DIMM

DESCRIPTION

This document describes ValueRAM’s 1024M x 72-bit 8GB

(8192MB) DDR3-1333MHz CL9 SDRAM (Synchronous DRAM)

registered w/parity, dual-rank memory module, based on thirty-

six 512M x 4-bit DDR3-1333MHz FBGA components. The SPD

is programmed to JEDEC standard latency 1333MHz timing of

9-9-9 at 1.5V. This 240-pin DIMM uses gold contact ngers and

requires +1.5V. The electrical and mechanical specications are

as follows:

FEATURES

• JEDEC standard 1.5V ± 0.075V Power Supply

• VDDQ = 1.5V ± 0.075V

• 667MHz fCK for 1333Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 6,7,8,9,10

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• Programmable CAS Write Latency(CWL) = 7(DDR3-1333)

• 8-bit pre-fetch

SPECIFICATIONS

CL(IDD) 9 cycles

Row Cycle Time (tRCmin) 49.5ns (min.)

Refresh to Active/Refresh 160ns (min.)
Command Time (tRFCmin)

Row Active Time (tRASmin) 36ns (min.)

Power 4.365 W (operating)

UL Rating 94 V - 0

Operating Temperature 0° C to 85° C

Storage Temperature -55° C to +100° C

• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does

not allow seamless read or write [either on the y using A12

or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• On-DIMM thermal sensor (Grade B)

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE ≤ 95°C

• Asynchronous Reset

• PCB : Height 1.180” (30.00mm), double sided component

Continued >>

Kingston.com Document No. VALUERAM0808-001.A00 07/17/09 Page 1

continued ValueRAM

MODULE DIMENSIONS:

Kingston.com Document No. VALUERAM0808-001.A00 07/17/09 Page 2