Kingston KVR1333D3D4R9S-4GED User Manual
Memory Module Specification
KVR1333D3D4R9S/4GED
4GB 512M x 72-Bit PC3-10600
CL9 Registered w/Parity 240-Pin DIMM
DESCRIPTION:
This document describes ValueRAM's 512M x 72-bit 4GB (4096MB) DDR3-1333MHz CL9 SDRAM (Synchronous
DRAM) registered w/parity, dual-rank memory module, based on thirty-six 256M x 4-bit DDR3-1333MHz FBGA
components. The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1.5V. This 240-pin DIMM
uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8,9,10
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 18.75mm, double sided component
PERFORMANCE:
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 110ns (min.)
Row Active Time (tRASmin) 36ns (min.)
Power 3.960 W (operating)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
DRAM Supported:
Elpida D-Die
Document No. VALUERAM0913-001.A00
05/10/10
Page 1
MODULE DIMENSIONS:
ValueRAM
(Units = millimeters)
Document No. VALUERAM0913-001.A00 Page 2
Loading...