Kingston KVR1066D3Q4R7SK216G User Manual

Memory Module Specification

KVR1066D3Q4R7SK2/16G

16GB (8GB 1024M x 72-Bit x 2 pcs.) PC3-8500

CL7 Registered w/Parity 240-Pin DIMM Kit

DESCRIPTION:

ValueRAM's KVR1066D3Q4R7SK2/16G is a kit of two 1024M x 72-bit 8GB (8192MB) DDR3-1066 CL7 SDRAM
(Synchronous DRAM) registered w/parity, quad-rank memory modules. Total kit capacity is 16GB. Each module is based
on thirty-six 256M x 4-Bit SDRAM internally stacked in eighteen DDP 512M x 4-Bit DDR3-1066 FBGA packages. The
SPDs are programmed to JEDEC standard latency 1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact
fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

FEATURES:

JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
533MHz fCK for 1066Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 6(DDR3-1066)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset

PCB : Height 30.50mm, double sided component, w/ Full DIMM Heat Spreader

PERFORMANCE:

CL(IDD) 7 cycles
Row Cycle Time (tRCmin) 50.63ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 110ns (min.)
Row Active Time (tRASmin) 37.5ns (min.)
Power 6.510 W (operating per module)
UL Rating 94 V - 0

Document No. VALUERAM0783-001.A00

05/09/09

Page 1

MODULE DIMENSIONS:

ValueRAM

Document No. VALUERAM0783-001.A00 Page 2