Kingston KVR1066D3N7K33G User Manual

Memory Module Specification

KVR1066D3N7K3/3G

3GB (1GB 128M x 64-Bit x 3 pcs.) PC3-8500

Triple-Channel CL7 240-Pin DIMM Kit

DESCRIPTION:

ValueRAM's KVR1066D3N7K3/3G is a triple-channel kit consisting of three 128M x 64-bit 1GB (1024MB) DDR3­1066 CL7 SDRAM (Synchronous DRAM) memory modules, based on eight 128M x 8-bit DDR3-1066 FBGA
components per module. Total kit capacity is 3GB (3072MB). The SPDs are programmed to JEDEC standard latency
1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and
mechanical specifications are as follows:

FEATURES:

JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
533MHz fCK for 1066Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8,9
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1066)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset

PCB : Height 1.180” (30.00mm), single sided component

PERFORMANCE:

CL(IDD) 7 cycles
Row Cycle Time (tRCmin) 50.63ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 110ns
Row Active Time (tRASmin) 37.5ns (min.)
Power 1.020 W (operating per module)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C

Document No. VALUERAM0715-001.A00

10/16/08

Page 1

MODULE DIMENSIONS:

ValueRAM

30.00

18.80

15.80

11.00

8.00

0.00

TECHNOLOGY

Units: millimeters

0.00

133.35

54.70

Document No. VALUERAM0715-001.A00 Page 2