![](/html/6d/6d4c/6d4cfb6b557a8cff08b11c935c8d3948f5a371316190e715650a30be5d4eec69/bg1.png)
Memory Module Specifi cations
KVR1066D3N7K2/8G
8GB (4GB 2Rx8 512M x 64-Bit x 2 pcs.)
PC3-8500 CL7 240-Pin DIMM Kit
Important Information: The module defined in this data sheet is one of several configurations available under
this part number. While all configurations are compatible, the DRAM combination and/or the module height may
vary from what is described here.
DESCRIPTION
ValueRAM's KVR1066D3N7K2/8G is a kit of two 512M x 64-bit
(4GB) DDR3-1066 CL7 SDRAM (Synchronous DRAM), 2Rx8
memory modules, based on sixteen 256M x 8-bit DDR3-1066
FBGA components per module. Total kit capacity is 8GB. The
SPD's are programmed to JEDEC standard latency DDR3-1066
timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact
fingers. The electrical and mechanical specifications are as
follows:
FEATURES
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 533MHz fCK for 1066Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 6 (DDR3-1066)
SPECIFICATIONS
CL(IDD) 7 cycles
Row Cycle Time (tRCmin) 50.63ns (min.)
Refresh to Active/Refresh 160ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 37.5ns (min.)
Power (Operating) 1.320 W* (per module)
UL Rating 94 V - 0
Operating Temperature 0
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
o
C to 85o C
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration: Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE
< 95°C
• Asynchronous Reset
• PCB: Height 1.18” (30mm), double sided component
Continued >>
Document No. VALUERAM0790-001.B00 08/17/11 Page 1
![](/html/6d/6d4c/6d4cfb6b557a8cff08b11c935c8d3948f5a371316190e715650a30be5d4eec69/bg2.png)
MODULE DIMENSIONS:
TECHNOLOGY
30.00
18.80
15.80
11.00
8.00
0.00
Units: millimeters
0.00
133.35
54.70
Document No. VALUERAM0790-001.B00 Page 2