Kingston KVR1066D3N7K22G User Manual
Memory Module Specification
KVR1066D3N7K2/2G
2GB (1GB 128M x 64-Bit x 2 pcs.) PC3-8500
CL7 240-Pin DIMM Kit
DESCRIPTION:
ValueRAM's KVR1066D3N7K2/2G is a kit of two 128M x 64-bit 1GB (1024MB) DDR3-1066 CL7 SDRAM (Synchronous DRAM) memory modules, based on sixteen 64M x 8-bit DDR3-1066 FBGA components per module. The SPDs
are programmed to JEDEC standard latency 1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact
fingers and requires +1.5V. The electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
533MHz fCK for 1066Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1066)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
1066Mbps CL7 doesn’t have backward compatibility with 800Mbps CL5
PCB : Height 1.180” (30.00mm), double sided component
PERFORMANCE:
CL(IDD) 7 cycles
Row Cycle Time (tRCmin) 50.63ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 90ns
Row Active Time (tRASmin) 37.5ns (min.)
Power TBD W (operating per module)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
Document No. VALUERAM0572-001.A00
06/27/08
Page 1
MODULE DIMENSIONS:
ValueRAM
30.00
18.80
15.80
11.00
8.00
0.00
TECHNOLOGY
Units: millimeters
0.00
133.35
54.70
Document No. VALUERAM0572-001.A00 Page 2
Loading...