Kingston KVR1066D3N7-2G User Manual

Memory Module Specifi cations
KVR1066D3N7/2G
2GB 2Rx8 256M x 64-Bit PC3-8500 CL7 240-Pin DIMM
Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here.
DESCRIPTION
This document describes ValueRAM's 256M x 64-bit (2GB) DDR3-1066 CL7 SDRAM (Synchronous DRAM), 2Rx8 memory module, based on sixteen 128M x 8-bit DDR3-1066 FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1066 timing of 7-7-7 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
533MHz fCK for 1066Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 6 (DDR3-1066)
8-bit pre-fetch
SPECIFICATIONS
CL(IDD) 7 cycles Row Cycle Time (tRCmin) 50.63ns (min.) Refresh to Active/Refresh 110ns (min.)
Command Time (tRFCmin) Row Active Time (tRASmin) 37.5ns (min.) Power (Operating) 1.560 W*
UL Rating 94 V - 0 Operating Temperature 0 Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
o
C to 85o C
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration: Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
Asynchronous Reset
PCB: Height 0.740” (18.75mm), double sided component
Continued >>
Document No. VALUERAM0621-001.C00 08/17/11 Page 1
MODULE DIMENSIONS:
(Units = Millimeters)
Document No. VALUERAM0621-001.C00 Page 2
Loading...