Kingston KVR1066D3E7S1GI User Manual
Memory Module Specification
KVR1066D3E7S/1GI
1GB 128M x 72-Bit PC3-8500
CL7 ECC 240-Pin DIMM
DESCRIPTION:
This document describes ValueRAM's 128M x 72-bit 1GB (1024MB) DDR3-1066MHz CL7 SDRAM (Synchronous DRAM) ECC memory module (Intel® Compatibility Tested), based on nine 128M x 8-bit DDR3-1066 FBGA components. The SPD is programmed to JEDEC standard latency 1066MHz timing of 7-7-7 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply VDDQ = 1.5V ± 0.075V
533MHz fCK for 1066Mb/sec/pin 8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10 Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 6(DDR3-1066) 8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset
PCB : Height 1.180” (30.00mm), single sided component
PERFORMANCE:
|
CL(IDD) |
7 cycles |
|
||
|
Row Cycle Time (tRCmin) |
50.63ns (min.) |
|
||
|
Refresh to Active/Refresh Command Time (tRFCmin) |
110ns |
|
||
|
Row Active Time (tRASmin) |
37.5ns (min.) |
|
||
|
Power |
0.810 W (operating) |
|
||
|
UL Rating |
94 V - 0 |
|
||
|
Operating Temperature |
0o C to 85o C |
|
||
|
Storage Temperature |
-55o C to +100o C |
|
Document No. VALUERAM0809-001.A00 |
07/31/09 |
Page 1 |
ValueRAM
MODULE DIMENSIONS:
T E C H N O L O G Y |
Units: millimeters |
133.35 |
30.00 |
|
18.80
15.80
11.00
8.00
0.00
|
|
|
0.00 |
54.70 |
|
Document No. VALUERAM0809-001.A00 |
Page 2 |
Loading...