Kingston KVR1066D3D8R7S2GI User Manual

Memory Module Specification

KVR1066D3D8R7S/2GI

2GB 256M x 72-Bit PC3-8500

CL7 Registered w/Parity 240-Pin DIMM

DESCRIPTION:

This document describes ValueRAM's 256M x 72-bit 2GB (2048MB) DDR3-1066MHz CL7 SDRAM (Synchronous DRAM), (Intel® Compatibility Tested), registered w/parity, dual-rank memory module, based on eighteen 128M x 8bit DDR3-1066 FBGA components. The SPD is programmed to JEDEC standard latency 1066MHz timing of 7-7-7 at

1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

FEATURES:

JEDEC standard 1.5V ± 0.075V Power Supply VDDQ = 1.5V ± 0.075V 533MHz fCK for 1066Mb/sec/pin 8 independent internal bank Programmable CAS Latency: 6,7,8,9,10 Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 6(DDR3-1066) 8-bit pre-fetch Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] Bi-directional Differential Data Strobe Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin On-DIMM thermal sensor (Grade B) Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset

PCB : Height 1.180” (30.00mm), double sided component

PERFORMANCE:

CL(IDD) 7 cycles Row Cycle Time (tRCmin) 50.625ns (min.) Refresh to Active/Refresh Command Time (tRFCmin) 110ns (min.) Row Active Time (tRASmin) 37.5ns (min.) Power 3.195 W (operating) UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C

Document No. VALUERAM0813-001.A00

07/31/09

Page 1

MODULE DIMENSIONS:

ValueRAM

(units = millimeters)

Document No. VALUERAM0813-001.A00 Page 2